Fish Grips and Lip Grippers: Where They Help and Harm

A lip grip is sold as a landing tool, and it is good at one job: holding a fish by the lower jaw while the other hand works. The same tool becomes a problem when it is used as a handle. Suspended vertically, every pound of the body pulls on the jaw joint, and a clamp set too deep presses the floor of the mouth instead of the mandible. The limit is weight and support, not brand.

fish handlingDifficulty 2/5
Cover illustration: Fish Grips and Lip Grippers: Where They Help and Harm

Key facts

Key factDetail
Texas jaw-hold limit5 lb (about 2.3 kg); above it, horizontal with two hands
Alaska ruleHorizontal support at any size; no jaw or gill-plate hold
Air exposureUnder 60 seconds
BogaGrip scale ranges15, 30 and 60 lb across three models
BogaGrip lengths9 in, 10.75 in and 15 in
Jaw load, 30°A 4 lb fish at 30° from vertical puts about 4.6 lb on the jaw
Jaw load, 60°The same 4 lb fish at 60° puts about 8 lb on the jaw
Release checkClamp opens before the hand leaves the belly

What the clamp actually holds

The rules below apply to released fish on a pier, a beach or a boat. After reading, you can look at a fish and decide whether the clamp belongs on its jaw, where it should sit, and when to put the tool away. The lower jaw of a bony fish is a lever. The mandible carries the bite, the jaw joint sits at the back corner, and the muscles that close the mouth run from the skull to the jaw. A clamp that closes on the front edge of the mandible holds a bony structure. A clamp that slides behind the jaw closes on soft tissue: the floor of the mouth, the hyoid arch that supports the tongue, and the gill arches immediately behind. That difference decides the outcome. Load applied to the mandible is carried by bone and joint. Load applied behind it is carried by tissue that evolved to move water, not to hang a body. A fish released with a torn mouth floor can swim away and die later from feeding failure or infection, which is why the placement of the jaws matters more than the closing force. Vertical suspension is the other half of the problem. The NOAA guidance is direct: support the weight of any fish lifted from the water along the length of its body, and never suspend a fish by its lip or mouth. Alaska's release instructions go further and rule out the jaw and gill plate at any size. The tool is a control point for the head, not a handle for the fish. A grip earns its place in two situations: the fish is calm enough to hold still, and the other hand is free to do the work. If either condition fails, the tool adds a step instead of removing one. That is also why a grip works better on a boat, where the fish has to be steadied over a hard deck, than on a beach where a wet hand and a slack line can do the same job.

Where a jaw hold is allowed

Texas gives a usable number. The state's catch-and-release guidance allows smaller fish under 5 pounds to be held upright from the lower jaw, by hand or with a gripper, and requires larger fish to be held horizontally with two hands. Five pounds is about 2.3 kilograms, which is a modest fish in most saltwater fisheries and a large one in freshwater. The number is a state rule, not a law of fish anatomy. Alaska, which manages salmon, halibut and rockfish, tells anglers to keep fish horizontal and never hold them by the jaw or gill plate. A reader who fishes both jurisdictions has to follow the stricter local rule, because the fish and the handling tradition differ. Check the agency page that covers your water, not a video from another coast. Black bass sit at the permissive end of the range. A bass has a wide, firm mandible and a jaw that opens far enough for a clamp to seat cleanly, which is why the hold became standard in bass fishing. The hold still needs the second hand under the belly when the fish is lifted clear of the water, and it still ends when the fish is heavy enough to sag. A fish kept for the table is a different case from a fish released. A jaw hold that bruises tissue matters little on a fish that goes into ice within the hour, and matters a great deal on a fish that swims away. Decide which fish is in the net before the clamp comes out; the release standard is the one that sets the rule.

Fish that should never see the clamp

Sharks and rays should never see the clamp. Their skeletons are cartilage, and the organs of many sharks are held in place by loose connective tissue. Texas warns that lifting a shark by the tail can tear that tissue; a jaw hold has no bony joint to carry the weight either. The guidance is to lay the fish horizontally, keep it in the water when possible, and support the body if it must come aboard. Toothy fish are a hand problem before they are a fish problem. A clamp on the jaw of a bluefish, a kingfish or a barracuda puts the angler's fingers beside a row of teeth while the fish thrashes. Use pliers or a hook remover, keep the head turned away, and hold the body behind the pectoral fins if a hold is needed at all. Flatfish and soft-jawed species tear at the clamp. A flounder's jaw is small and flexible, and the clamp needs a bony edge to bite against. A net and two wet hands distribute the load across the body. The same applies to any fish whose mouth is smaller than the grip's jaw span: the tool cannot close on bone, so it closes on tissue. A deep-hooked fish is the fourth refusal. The clamp occupies the mouth exactly where the hook sits, and the angler then works around the tool to reach a hook in the throat. Leave the fish in the water, use forceps or a dehooker, and cut the line close to the hook when the hook cannot be backed out. The grip can wait until the hook is gone. Heavy fish are the final refusal, and the easiest to judge. If the fish's body sagged when the line came tight, the jaw is not a lifting point. The 5-pound line in the Texas rule is a useful ceiling for a vertical hold, and the second hand belongs under the belly well before that line is reached.

Angle, load and the second hand

The angle of the hold sets the load. A fish hanging straight down from the clamp puts its full weight on the jaw. At 30 degrees from vertical, the tension rises to about 1.15 times the weight, so a 4-pound fish loads the jaw at roughly 4.6 pounds. At 60 degrees, the factor is 2, and the same fish puts about 8 pounds on the jaw. That arithmetic is why a horizontal hold is not just a courtesy. When the body is level, the second hand carries most of the mass and the clamp only resists the head turning. When the body hangs, the clamp carries everything. The wrist strap does not change the load; it stops the tool from going overboard. BogaGrip publishes scale ranges for three models: the 315 weighs fish to 15 pounds in quarter-pound steps and measures 9 inches, the 130 goes to 30 pounds in half-pound steps and measures 10.75 inches, and the 260 reaches 60 pounds in half-pound steps at 15 inches. Those numbers describe what the scale can read. They are not a safe hanging limit for a jaw. The Rapala floating gripper is built for a different job: a one-hand hold with a quick-release trigger, a plastic body and a wrist lanyard. The description claims a secure hold and an easy release, and both are useful on a boat. Neither feature moves weight off the jaw, so the second hand still goes under the fish. Set the clamp so the jaws close on the front edge of the mandible, with the tool's body pointing away from the gill cover. A clamp that sits deep in the mouth presses the tongue arch and gives the fish nothing solid to pull against. If the jaws cannot close on bone, the fish is a net fish.

Release the clamp without tearing the jaw

Release is a sequence, and the order protects the jaw. Bring the fish alongside, keep the head in the water, and open the clamp before lifting anything. With the fish supported by the hand under the belly, slide the jaws off along the mandible rather than twisting them free. A clamp that is twisted under load is how a jaw gets torn at the release. The NOAA handling rules apply throughout: wet hands, no contact with eyes or gills, and less than 60 seconds of air exposure when the fish must leave the water. Cut the line close to the hook when a swallowed hook cannot be removed. A fish that is bleeding at the mouth should go back without more handling, not into a second grip for a photograph. If the clamp sticks, stop pulling. Open the trigger fully, let the spring relax, and ease the jaws apart with the fish still in the water. Corrosion, sand and dried salt all make a sticky trigger, and a sticky trigger is the tool failure that damages fish. Rinse the grip after every saltwater session and work the trigger while it dries. A jaw that hangs open after release is a signal, not a curiosity. Support the fish in the current until it holds itself upright and swims away. If it cannot, the damage is already done, and the next fish should be handled with the second hand under the belly from the first second. The cost of that correction is one hand, which is cheaper than a lost fish.

Build the use and no-use list

Build the list for your own water rather than memorising a species chart. Start with the local agency rule for jaw holds, then add the weight ceiling you can support with one hand while the other works. The result is short and specific, and it fits on a note inside the tackle box. Use the clamp when: The fish is under 5 pounds and has a firm, wide mandible. The hook sits at the lip and the fish will not hold still. The other hand is under the belly before the fish leaves the water. The local rule allows a jaw hold and the fish is not a shark, ray or flatfish. Do not use it when: The fish is heavy enough to sag the jaw or pull the hand down. The fish has teeth near the jaw, or the hook is deep in the throat. The species is a shark, a ray or a soft-jawed flatfish. The clamp is wider than the mandible or cannot close on bone. The plan is to carry, weigh or photograph the fish hanging free. Two lists, one tool, no ambiguity. A grip used inside the list saves fingers and time; a grip used outside it turns a released fish into a damaged one. The list is worth rewriting once a season, because the fish you catch and the hand you can spare both change.

Check the tool and the fish before the lift

Check the tool before the first fish. Squeeze the trigger and watch both jaws open and close together. Look for corrosion at the pivot, sand in the spring, and a lanyard that has frayed at the knot. Wet the jaws before they touch a fish, because dry metal and dry plastic both strip the mucus layer that protects the skin. Check the fish at the same time. Compare the width of the mandible with the jaw span of the tool, and look at where the hook sits. If the clamp would have to pass the hook to reach the jaw, the hook comes out first. If the jaw is smaller than the span, the net comes out instead. The rule that survives every jurisdiction is simple: the grip holds the head, and the hand carries the fish. A tool asked to do more than that will eventually fail, and the fish pays for the failure. Keep the second hand under the belly, keep the air exposure short, and put the clamp away when the fish is too big for it.

Sources

  1. Catch and Release Fishing Best Practices — NOAA Fisheries · T1
  2. Proper Release Methods — Alaska Department of Fish and Game · T1
  3. Catch & Release Tips — Texas Parks and Wildlife Department · T1
  4. Catch and Release Techniques for Sharks — Texas Parks and Wildlife Department · T1
  5. BogaGrip Models 315, 130 and 260 — Eastaboga Tackle Manufacturing Company · T2
  6. Floating Fish Gripper — Rapala · T2