Vertical Jigging: Count the Fall, Follow the Drop

The jig hits bottom, the rod lifts, and the lure comes back without a touch. The next drop lands somewhere else because the boat has moved, the line is no longer vertical, and the angler has lost track of how far the jig sits above the floor. Vertical jigging fails in those small gaps. A counted fall, a fixed lift height and a followed drop turn a drifting boat into a repeatable presentation.

casting and controlDifficulty 2/5
Cover illustration: Vertical Jigging: Count the Fall, Follow the Drop

Key facts

Key factDetail
Line angleWithin 10 degrees of vertical
Jig weight range40 g to 420 g across the vertical range
Sink count30 m in 12 seconds equals 2.5 m per second
Bottom height0.3 to 0.5 m above the floor
Short lift30 to 50 cm
Long sweep60 to 90 cm
Set length180 seconds, about 8 drops

The line angle decides where the jig is

The decision is how to set one three-minute drift: how much line to let out, how high to lift, and when to reset instead of fishing dead water. A jig on a vertical line is a different lure from a jig on a swept line. Lift a vertical jig and it rises. Lift a swept jig and it rises and slides sideways, which pulls it out of the bottom layer and changes the angle of every later drop. Keep the line within 10 degrees of vertical. Past 20 degrees, the lift becomes a diagonal pull, the jig lands behind the boat, and the fall is no longer a fall. The fish see a lure travelling across the current instead of one dropping through it. Weight is the first correction. Nomad lists vertical jigs from 40 g (1-1/2 oz) to 420 g (15 oz), with the fast-sink models at the heavy end. A heavier jig reaches bottom faster and holds a steeper line. A lighter jig flutters longer but sweeps away in current. Check the angle at the end of the drop, not at the start. The line leaves the rod tip near vertical on the release and sweeps out as the boat drifts. The angle at the moment the jig touches bottom is the one that governs the lift. If the line is past 10 degrees at the end of the drop, use a heavier jig, shorten the cast, or move the boat upcurrent of the mark. Adding weight alone steepens the line but speeds the fall, which shortens the time the jig spends in front of the fish. Correct the angle before the next drop; a lift from a swept line teaches the wrong rhythm.

Count the fall before the first lift

The count is the depth control. Drop the jig on a closed spool with the thumb light on the line, and count from the moment the line stops paying out to the moment it ticks bottom. Write that number down for the first drop of the set. A jig that reaches 30 m in 12 seconds is falling at 2.5 m per second. That rate belongs to the jig, the line and the current of the day. It is not a catalogue number and it changes when any of those three change. Repeat the count on every drop. A count that shortens by 3 seconds means shallower water, less current, or a jig that is planing. A count that lengthens means deeper water, more sweep, or a lure that has picked up weed. The count also sets the lift. If the jig falls 2.5 m per second, a 50 cm lift returns to the bottom in about 0.2 seconds. The pause comes after contact, not during the fall. Metered braid makes the count easier, but a marker on the line works. Tie a small stopper or mark the line at a known depth, then watch the mark pass the rod tip. The count and the mark should agree; when they do not, the drift has changed the depth. A marker also shows the moment the jig leaves the band on the retrieve, which is when a following fish often commits.

Lift height and rod input

A short lift moves the rod tip 20 to 30 cm and the jig 30 to 50 cm. The motion comes from the wrist and forearm, and the rod stays in line with the line. The jig darts up, then falls back through the same water. A long sweep moves the jig 60 to 90 cm. The whole arm drives it, the rod loads deeper, and the fall takes longer. Use it when the fish are spread through a thicker layer or when the current is too strong for a short, quick input. Match the input to the jig. A balanced minnow profile such as the Rapala Jigging Rap, 2-3/4 in and 5/8 oz, sinks on its own and swims in a circle on the lift. It needs a short input and a long fall. A heavy fast-sink jig needs a sharper lift to get the same sideways kick. Keep the rod tip pointed at the line. Pulling across the body adds a horizontal component and changes the line angle, which is the one variable the whole method depends on. The rod should load and unload in the same plane as the line. Hold the same lift for the whole set. A set with three different lift heights cannot be read: the fish refused the height, the speed or the fall. One height per set gives one answer. Say the height aloud at the start and keep it until the set ends. A note on the reel or a mark on the rod butt records it, and without a record the next set starts from memory and drifts.

Follow the drop

Lower the rod at the speed of the fall. The tip follows the line down, and the line stays just short of tight. That semi-slack line lets the jig flutter and still carries a tap back to the hand. Do not wind the jig down. Reeling takes the fall out of the presentation and turns a fluttering lure into a weight on a string. The fall is when a jig looks most like a wounded baitfish, and it is often when the take arrives. Watch for a jump or a stall in the line. A line that goes slack while the jig is still falling means a fish has taken. Lift the rod first, then reel. Reeling into the take pulls the jig away and adds slack at the same moment. A tight line kills the flutter; a slack line hides the take and tangles around the jig. Aim for the middle. The line should be straight enough to show a tick and loose enough that the jig is not being dragged. The Jigging Rap is built to sink and swim in circles, so the fall is part of its action. The same rule applies to any jig with a balanced body: let the design work on the drop instead of overriding it with the reel. A balanced body does not need a hard rip to swim; dropping the tip supplies the motion. The reel only recovers line between drops.

Hold the height above the bottom

The bottom is a reference point, not always the target. Black sea bass prefer reefs, wrecks and oyster beds. Atlantic cod sit near rocky slopes and ledges in water from 30 to 500 ft, which is roughly 9 to 152 m. Both are structure-oriented fish, and the structure they use sits on the bottom. Set the jig 0.3 to 0.5 m above the floor, about the length of a forearm. That gap keeps the lure in the feeding band and out of the snag. A jig dragged on the bottom catches shell and rock; a jig two metres up fishes empty water. After the jig touches, lift 30 to 50 cm and start the rhythm. The fall should stop just above the floor, not on it. The stop is the point where the jig hangs in front of a fish that is looking up. If the jig ticks on every drop, it is on the floor and the snag risk is high. If it never ticks, it is fishing high. Adjust by 0.5 m at a time, using the count to confirm the change. Structure creates the productive band. A wreck, a reef edge or a shell bank holds fish within about 1 m of the hard bottom. The jig has to pass through that band on every lift, which is why the height check matters more than the length of the cast. A jig that passes a metre to the side of the edge fishes the same water as one over sand.

Judge drift and current sweep

The line angle at the end of the drop is the drift gauge. More than 10 to 15 degrees means the boat is moving faster than the jig can sink, or the current is pushing the line away. The next lift will pull the jig diagonally, and the presentation changes. Three corrections are available. Use a heavier jig, shorten the drift, or reposition the boat upcurrent. Weight alone is the weakest fix because it speeds the fall and shortens the time the jig spends in the strike layer. Watch the count as well as the angle. If it lengthens by 3 seconds over 15 minutes, the drift has carried the boat off the mark or the current has built. Both change the depth the jig reaches on the same amount of line. Reset after two consecutive count changes. Fishing a mark the boat has left produces no bottom contact and no fish, and the angler often reads that as a dead spot rather than a drift problem.

Rhythm by depth band

The drop to bottom takes longer as the water deepens, so the same set holds fewer lifts. At 60 m a 60 g jig needs a longer count than it does at 20 m, and the 3-minute set gives up a drop or two. The pause at the bottom stays short; the count, not the clock, sets the cycle. Use these bands as starting points: 10 to 30 m: 30 to 50 cm lift, 2 second pause, 8 lifts per drop. 30 to 60 m: 40 to 60 cm lift, 2 to 3 second pause, 6 lifts per drop. 60 to 100 m: 60 to 80 cm lift, 3 second pause, 4 lifts per drop. Below 100 m: 80 to 100 cm sweep, 3 to 4 second pause, 3 lifts per drop. The count decides when the band changes. When the count to bottom lengthens past the band, the lift has to grow with it. A deeper drop with the same short lift leaves the jig above the fish for most of the cycle. A band that stops producing bottom contact is a signal to change weight, not to speed up the lift.

The three-minute set

A set of 180 seconds is long enough for about 8 drops and short enough to keep the jig on the mark. The clock is a boundary, not a cue to stop mid-lift. Finish the lift, then reset, and treat a set cut short after a take as a completed set. The count, not the timer, decides when the next drop starts. Run it in the same order every time: 1. At 0:00, drop and count to bottom. Note the seconds. 2. At 0:10, lift 30 to 50 cm and begin 8 lifts with a 2 second pause. 3. At 1:40, check the line angle and the count. Reset if either has changed. 4. At 1:50, re-drop and run 6 lifts on the same height. 5. At 2:40, make the last drop and finish with 3 long sweeps. 6. At 3:00, retrieve and reset the drift before the next set. A set that produces no bottom contact in the first 2 drops is a tackle problem. The remaining time goes to the angle and the weight, not to more lifts. A set that produces contact but no fish gets one change: a different lift height or a longer pause after the fall. Before the next drop, check three things: the count to bottom, the line angle at the end of the fall, and the height of the first lift. When those three match the previous set, the presentation is repeatable, and the next change you make will mean something.

Sources

  1. Black Sea Bass — NOAA Fisheries · T1
  2. Atlantic Cod — NOAA Fisheries · T1
  3. Jigs & Vibes — Nomad Tackle · T2
  4. Jigging Rap — Rapala · T2