Night Fishing Lights: Power, Backup and Being Seen

Dark removes most of the cues that keep a boat out of trouble. The channel looks like open water, the unlit mooring looks like a gap, and a drifting hull looks like a shadow until it is close. Three lighting jobs follow from that: seeing your rig, seeing the route, and being seen. The third job has legal shapes and colours, and the first two are solved with a headlamp and a spare battery.

safety and etiquetteDifficulty 2/5
Cover illustration: Night Fishing Lights: Power, Backup and Being Seen

Key facts

Key factDetail
Powerboat under 12 mSidelights plus one all-round white light may replace masthead and sternlight
Sidelight arc112.5 degrees, red to port, green to starboard
Masthead arc225 degrees
Sternlight arc135 degrees
Visibility under 12 mSidelights 1 nautical mile; masthead, stern and all-round 2
Sail under 20 mSidelights and sternlight, or one combined lantern at the masthead
Sail or oar under 7 mAll-round white light, or a torch shown in time
At anchorOne all-round white light where best seen; under 7 m exempt outside channels

What the rules require after dark

The sections below separate the three, give the arcs and distances the rules require, and finish with a check that runs while there is still daylight to see the result. Navigation lights are signals, not lamps. They tell another skipper what kind of vessel is out there, which side is facing them, and whether the two courses are closing. Rule 21 fixes the arcs that carry that meaning. A masthead light shows an unbroken white over 225 degrees, from right ahead to 22.5 degrees abaft the beam on either side. A sidelight shows 112.5 degrees, red on port and green on starboard. A sternlight shows 135 degrees, 67.5 degrees from right aft on each side. An all-round light shows 360 degrees. Rule 22 fixes the distance at which each light must be visible. Below 12 m, a sidelight must carry 1 nautical mile, while a masthead light, sternlight and all-round light must carry 2. Between 12 and 50 m, a masthead light must carry 5 miles, except that a vessel under 20 m may show 3, and the sidelights and sternlight must carry 2. At 50 m and above, the masthead light must carry 6 miles and the sidelights and sternlight 3. The ranges explain why a cheap clamp-on light can fail the rule without failing visibly. A 2-mile sternlight on a small boat sits close to the water and is often masked by a swell, a motor, or a cooler. The rule describes clear visibility in a dark sky, not the view through spray. A light that sits low, shines through plastic, or runs on a dying cell may meet the label and miss the purpose. The arcs also explain what other skippers read. A single white light ahead suggests a vessel at anchor. A white light with red and green below it suggests a power-driven vessel coming toward you. Red alone, with a white behind it, suggests you are looking at the port side and the vessel is crossing. Those readings are why the colours and arcs are fixed.

Power, sail and paddle: three light sets

A power-driven vessel underway shows a masthead light forward, sidelights, and a sternlight. A second masthead light, higher and abaft the first, is required at 50 m and above and optional below that. A power-driven vessel under 12 m may instead show one all-round white light and its sidelights, which is the practical option for most open boats and skiffs. The all-round light covers both the masthead and stern arcs in one fixture. A sailing vessel underway shows sidelights and a sternlight. Below 20 m, those lights may be combined in one lantern at or near the top of the mast. A sailing vessel under 7 m must show that set if practicable; when it does not, it shows an all-round white light or keeps a torch or lantern ready and shows it in time to prevent a collision. A paddler may carry the sailing set, or use the same all-round light or torch option. A sailing vessel proceeding under sail and machinery counts as power-driven and must show a forward masthead light. A vessel of 12 m or more must also show a cone, apex down, where it can best be seen; below 12 m the cone is optional. The switch from sail to power is a switch in light configuration, and the crew on deck needs to know which one is in force. A paddlecraft is the hardest case. A kayak or canoe under oars can meet the rule with an all-round white light, and a torch shown in time is the fallback. A headlamp strapped to the forehead is directional and low, so it does not replace an all-round light at deck level. A short mast or a rear-deck light, plus a torch in the PFD, covers both signals.

Anchor, mooring and the empty boat

A vessel at anchor shows an all-round white light where it can best be seen. Below 50 m, one light is enough. At 50 m and above, the rule asks for a second all-round white at or near the stern and lower than the forward one, so the two ends of the hull are marked. A black ball by day marks the same state. The exemptions are narrow and easy to misread. A vessel under 7 m at anchor is not required to show the light or shape when it is not in or near a narrow channel, a fairway, an anchorage, or a place where other vessels normally navigate. A vessel under 20 m at anchor in a special anchorage area designated by the Coast Guard is also exempt. Both exemptions depend on location, not on the skipper's confidence that the spot is quiet. A vessel aground shows the anchor lights and, if practicable, two all-round red lights in a vertical line plus three balls in a vertical line. A vessel under 12 m when aground is not required to show those extra red lights and balls. The anchor light still marks the hull, which is the part another vessel can hit. For a night angler, the anchor case is the one that catches people. A boat anchored on a ledge, outside the channel and away from the ramp, feels invisible, and the rule still asks for the light unless the boat is under 7 m and genuinely outside the exempt locations. A light clamped below the outboard marks the motor rather than the hull, and a swell can hide it from a passing boat.

Headlamp settings and runtime

A headlamp is a work light with a battery budget. The Petzl ACTIK illustrates the trade: 450 lumens at maximum for 2 hours, 100 lumens for 10 hours, 7 lumens for 100 hours, and a red setting at 2 lumens for 60 hours. The strobe is visible at 700 m for 400 hours, a figure that describes signalling rather than seeing. The same lamp weighs 98 g and runs on three AAA cells or a rechargeable pack. The runtime curve is not linear: dropping from 450 to 100 lumens multiplies runtime by five. The low setting ties a knot, baits a hook or finds a dropped weight; maximum output belongs in short bursts. A lamp left on maximum while rigging will be flat before the tide turns. The red setting protects night vision and keeps the beam from blinding the crew. It is too dim for fine work at a distance, so the useful pattern is red for moving around the boat and a low white beam for knots and baits. A red beam on a chart leaves the print hard to read; a white beam on a skipper erases their adaptation for minutes. Water and switches are the common failures. IPX4 covers rain and spray, not a drop overboard; a wet lamp needs to dry before the next trip and the battery compartment needs a corrosion check. The lock function exists because a lamp switched on inside a gear bag will be flat when needed. A phone torch is a backup with a cost: the beam is wide and flat, it drains fast, and it shares the battery with calls and charts. Use it for a look under a seat, then return it to the dry bag.

Dark adaptation and other people's eyes

The eye takes time to rebuild its sensitivity after a bright light. A white beam at close range resets that process, and the person who received it has to wait through the minutes it takes to see the water again. Red light is used at night because it preserves most of that adaptation, which is why a red headlamp setting is a courtesy as well as a working mode. A headlamp on the forehead points wherever the wearer looks. Looking at a skipper to ask a question puts the beam straight into their eyes. Looking down at a knot points it at the deck, which is the useful direction. Tilting the lamp down, holding it in the hand, or using a chest light keeps the beam where the work is and away from other faces. Approaching another boat at night calls for a deliberate change. Switch to red or the lowest white setting before coming alongside, call out which side you are on, and avoid sweeping the beam across their cockpit. A bright sweep reads as a signal or a warning, and it destroys the other crew's night vision at the moment they are handling lines. Your own dark adaptation has a cost in navigation. A chart lit at full white, a phone screen at maximum, and a headlamp aimed at the horizon all reduce the sensitivity needed to see an unlit buoy. Use the lowest setting that does the job, dim the screen, and look slightly to the side of a faint object so the sensitive part of the eye does the work. Keep one light that is only for signalling. A strobe or high beam used for work becomes ordinary and loses its value as a distress signal. A separate small torch, or a lamp with a strobe mode kept in reserve, gives a searchlight something unambiguous to see.

Reflective gear and a shore mark

Retroreflective material returns light toward its source. A searchlight sweeping a PFD with reflective patches produces a bright return from the same bearing, which is easier to spot than a matte jacket that scatters light in all directions. Tape on the shoulders of a PFD, the back of a hat, and the topsides of a small boat adds a passive signal that costs no battery. A headlamp only shows where the wearer is looking; the same person with the lamp off is a dark shape. Reflective tape on the PFD, the paddle blades and the hull gives a passing searchlight something to find. A shore mark is the other half of the plan. Before dark, pick a transit: two fixed objects that line up on the bearing you want, such as a pylon and a chimney. Note the bearing and the depth at the mark, and count the pilings between the channel and the exit. A transit survives darkness better than a memory of a beach. Light patterns change after sunset: a fixed light and a flashing light at the same distance look different, and a shore light that was off in the afternoon can be on at night. Note the colour and rhythm of the mark, not only its position. The exit itself needs a physical cue. A stick driven into the sand, a rock above the tide line, or a buoy left at the turn marks the spot when the beach has lost its shape. Take the cue with you or remove it on the way out, and tell someone the exit time before dark. A phone left in a bag is not a plan.

Field check after sunset

Run this while there is still enough light to see the result. The list covers the three jobs in the order they fail: the work light, the signals, and the way home. Every lamp switched on, lens clean, battery fresh, and the lock engaged for transit. Navigation lights fitted and visible from the helm; no rod holder, flag, or cooler inside the arc. Sidelights showing red to port and green to starboard, checked by walking around the bow. Sternlight and all-round light clear of the motor and high enough to survive a swell. Anchor light tested and mounted where the whole hull is marked, not just the stern cleat. Headlamp set to red or low, with spare cells and a second torch in a dry bag. PFD worn with reflective patches exposed; paddle or boat topsides carrying tape. Shore transit noted, exit cue placed, and the return time told to someone on shore. A light that fails on the water cannot be repaired by intention. The check is short, and it is the last moment the whole system can be seen from another skipper's position.

Editorial note

- s1 U.S. Coast Guard, 33 CFR 83.21: Definitions (Rule 21), https://www.ecfr.gov/current/title-33/chapter-I/subchapter-E/part-83/subpart-C/section-83.21, T1, accessed 2026-11-14 - s2 U.S. Coast Guard, 33 CFR 83.22: Visibility of Lights (Rule 22), https://www.ecfr.gov/current/title-33/chapter-I/subchapter-E/part-83/subpart-C/section-83.22, T1, accessed 2026-11-14 - s3 U.S. Coast Guard, 33 CFR 83.23: Power-driven Vessels Underway (Rule 23), https://www.ecfr.gov/current/title-33/chapter-I/subchapter-E/part-83/subpart-C/section-83.23, T1, accessed 2026-11-14 - s4 U.S. Coast Guard, 33 CFR 83.25: Sailing Vessels Underway and Vessels Under Oars (Rule 25), https://www.ecfr.gov/current/title-33/chapter-I/subchapter-E/part-83/subpart-C/section-83.25, T1, accessed 2026-11-14 - s5 U.S. Coast Guard, 33 CFR 83.30: Vessels Anchored, Aground and Moored Barges (Rule 30), https://www.ecfr.gov/current/title-33/chapter-I/subchapter-E/part-83/subpart-C/section-83.30, T1, accessed 2026-11-14 - s6 Petzl, ACTIK Headlamp: Lighting Performance and Technical Information, https://www.petzl.com/INT/en/Sport/Headlamps/ACTIK, T2, accessed 2026-11-14

Sources

  1. 33 CFR 83.21: Definitions (Rule 21) — U.S. Coast Guard · T1
  2. 33 CFR 83.22: Visibility of Lights (Rule 22) — U.S. Coast Guard · T1
  3. 33 CFR 83.23: Power-driven Vessels Underway (Rule 23) — U.S. Coast Guard · T1
  4. 33 CFR 83.25: Sailing Vessels Underway and Vessels Under Oars (Rule 25) — U.S. Coast Guard · T1
  5. 33 CFR 83.30: Vessels Anchored, Aground and Moored Barges (Rule 30) — U.S. Coast Guard · T1
  6. ACTIK Headlamp: Lighting Performance and Technical Information — Petzl · T2