Key facts
| Key fact | Detail |
|---|---|
| Read the station first | Every prediction belongs to one station |
| Lunar day | Two highs and two lows every 24 h 50 min |
| High to high | 12 h 25 min |
| High to low | 6 h 12.5 min |
| US working datum | Mean Lower Low Water at most stations |
| Two range measures | MN and GT use different pairs of highs and lows |
| What the table predicts | The astronomical tide only |
| Wind error in a bay | Water can sit 1–2 ft off the prediction |
| Weather delay at Galveston | An hour or more |
Start with the station, not the tide
The printed high gets treated as the moment the water stops, or a height read at one inlet gets applied to a beach two kilometres away. A fixed order removes both errors: station, datum, interval, range, weather. Work that order once and you can set an arrival time and a wading limit before you leave the house. A tide prediction covers one station, not a stretch of coast. NOAA generates tide tables for more than 3,000 locations in the United States, and every line on the page belongs to that station's gauge and its own datum. Two stations a short drive apart can differ in the time of high water and in how much water arrives. The station nearest the access road is the one to read. Inlets and open beaches sit at opposite ends of that spread. An inlet constricts the flow, so its heights and timing follow the channel rather than the sand outside. An open beach responds to the swell and the shelf slope. Copying a high-water time from a harbour table onto a beach plan produces a schedule that is wrong before the first cast. The station also fixes the scale. A height of 4 ft at one gauge is not 4 ft at another, and it is not 4 ft of water over a sandbar. Pick the gauge, write its number on the printout, and read every later number against that single reference. The page header carries three settings that change the reading. The station identifier ties the numbers to one gauge. The units switch between feet and metres, so a 1.4 reading means different water in each column. The time zone decides whether the printed clock has already been shifted for daylight saving, which the NOAA interface labels as LST/LDT, or stays on standard time, labelled LST. Read those three labels before the first tide line.
The datum turns a height into a local scale
The datum is the base elevation that heights are measured from. At most US stations the working datum is Mean Lower Low Water, computed by averaging the lower of each day's two low waters across the National Tidal Datum Epoch. A predicted 4 ft therefore means 4 ft above that averaged low, not 4 ft of water at the end of the groyne. Two bounds keep the scale honest. Highest Astronomical Tide and Lowest Astronomical Tide mark the extremes expected at the station over a 40-year period that covers two datum epochs. A prediction should not climb above HAT or fall below LAT. When a number sits outside those bounds, the station or the units are wrong. The practical link is a fixed mark. On the beach, choose a rock, piling or weed line that the water reaches at the height you plan around. A bar that dries at low water belongs to the tidal wetland class that is covered at high tide and exposed, or covered by about 1 ft, at low tide. That is the mark to watch.
Two highs, two lows, 50 minutes later each day
A lunar day lasts 24 hours and 50 minutes, which is 50 minutes longer than the solar day. The moon moves eastward while the Earth turns, so the planet needs those extra minutes to bring the same point back under the moon. Coastal water therefore runs two high and two low tides inside one lunar day, not inside one calendar day. The spacing follows from that. High tides sit 12 hours 25 minutes apart, and the water takes 6 hours 12.5 minutes to travel from high to low or from low to high. Each day holds two rising windows and two falling windows. The pair is rarely equal: one high stands above the other, and one low drops below its partner. The daily shift is the number to carry. Tomorrow's high arrives about 50 minutes later than today's, so adding 24 hours to a printed time puts the plan nearly an hour early. Add a day and 50 minutes, or read tomorrow's line from the table.
Work through one sample day
The table below is a worked example built to show the arithmetic, not a record from a station. It holds four lines across one lunar day, with two highs and two lows and a time zone that stays fixed. | Time | Stage | Height | Change | |---|---|---|---| | 03:12 | Low | 0.4 ft | — | | 09:26 | High | 4.6 ft | +4.2 ft | | 15:38 | Low | 0.7 ft | −3.9 ft | | 21:51 | High | 4.3 ft | +3.6 ft | Read the stage column before the heights. The first line is a low, so the water rises for the next six hours and the plan for a falling tide starts after the second line. The change column gives direction without arithmetic: a positive figure is rising water, a negative figure is falling water. Now take the range from the first pair. The high of 4.6 ft minus the low of 0.4 ft gives 4.2 ft of water between them. The intervals between lines are 6 h 14 min, 6 h 12 min and 6 h 13 min, which scatter around the 6 h 12.5 min average. That consistency is a check on the reading, not a coincidence. A range of 4.2 ft sets the trip. A beach with that range exposes a wide band of sand at low water and covers it again within six hours. Fish the falling half and leave the walk back inside the time the water needs to return. The clock label matters most in summer. A table generated in LST/LDT already follows the shift that a summer clock makes, so the printed 09:26 is the time on a phone in July. A table generated in LST stays one hour behind that phone. Set the prediction to LST/LDT when comparing against a watch, and keep a single setting for the whole plan so the correction is not applied twice.
Range separates a spring tide from a neap
Two published measures describe range, and they use different pairs. Mean range, MN, is mean high water minus mean low water. Great diurnal range, GT, is mean higher high water minus mean lower low water. GT is the larger figure because it takes the extreme of each unequal pair, so a station can show a modest MN and a GT large enough to change a wading plan. Spring and neap tides move both figures. At new and full moon the sun, moon and Earth line up, the solar tide adds to the lunar tide, and the highs run higher while the lows run lower. One week later the sun and moon sit at right angles, the solar tide cancels part of the lunar pull, and the range shrinks. Each lunar month carries two spring sets and two neap sets. Range decides how far a plan can bend. A small range keeps a flat fishable longer and leaves a shallow bar barely covered at high water. A large range drains the same flat far enough to walk, then refills it with enough flow to move a plain sinker. Read the pair for the day rather than the word on the calendar, because a neap high can sit below a spring low at the same station.
A printed high is not slack water
A height table and a current table are separate products. NOAA publishes current predictions for more than 2,500 locations, with flood, ebb and slack times listed for each. A tide table gives the level at a station and says nothing about when the flow through an inlet stops. The current listing has its own columns and its own vocabulary. Flood is the inflow, ebb is the outflow, and slack is the pause between them, with a speed attached to each turn. A tide line has a stage and a height and no speed at all. Reading one as if it were the other is the commonest first-trip error. The two do not coincide because they measure different things. Height is the level of the water surface; current is the volume moving past a point, driven by the slope of that surface. The slope can persist after the height peaks, and an inlet can keep running while the gauge reads high. A printed high is a level, not a stop sign. That has a scheduling consequence. Be set up before the printed high if the plan depends on the last of the flood, because rigging, walking and reading the water consume the stage you came for. A one-hour window cannot absorb twenty minutes of setup.
Weather moves water the table cannot see
The predictions are astronomical. Wind, rain, freshwater runoff and barometric pressure sit outside the calculation, and their effect is largest where the range is small. Along a bay, wind blowing down the length of the water has been known to hold levels 1–2 ft above or below the prediction. In shallow water and small-range stations, short-term weather can mask the astronomical tide altogether. Galveston shows the size of the error. The station sits in a shallow bay with a narrow opening, and meteorological events can delay or accelerate the predicted tides by an hour or more. A plan built on the printed time alone can arrive after the water has already turned. The size of the station's range decides how much weather can matter. A coast with a 10 ft range absorbs a foot of wind setup inside the normal rise and fall. A bay with a 1 ft range does not, which is why the same wind can erase the predicted low there and barely register on an open ocean beach. The check is a comparison, not a guess. Look at the observed level at the same station before leaving, and compare it with the predicted line for that hour. Water above prediction means the low will not expose the bar you planned to cross; water below means the high will not reach the ledge.
The reading order to keep
Confirm the station number matches the water you will fish. Note the datum and read heights as elevations on that scale. Take the day's range from the high and low pair. Add 50 minutes for tomorrow before writing the arrival time. Compare observed and predicted levels on the morning of the trip. At the access, look at the bar. If the printed low has arrived and the bar still carries water, the residual is positive, and the walk you planned is not there. Move the plan to the next low or fish the edge of the drop instead.
Sources
- Frequently Asked Questions — NOAA Tides and Currents · T1
- Tides and Water Levels: Frequency of Tides — NOAA National Ocean Service · T1
- Tidal Datums — NOAA Tides and Currents · T1
- Tides and Water Levels: Tidal Variations — NOAA National Ocean Service · T1
- Tidal Wetlands Categories — New York State Department of Environmental Conservation · T1
- Tide Predictions - Help — NOAA Tides and Currents · T1