Flood Jet: The Incoming Push and the Salt Wedge

Low water passes, and for a while nothing seems to happen. Then a line of rougher water appears at the inlet mouth, the colour changes from river brown to sea green, and the current begins to run inward along the bottom before the surface has moved much at all. That is the flood jet, and it is the moment the estuary changes direction.

tides
Cover illustration: Flood Jet: The Incoming Push and the Salt Wedge

Key facts

QuestionAnswer
What arrivesA leading edge of incoming water
Subsurface formSalt wedge along the bottom
Surface signColour change, foam line, rougher water
TimingAfter low water, often one to two hours later
SpeedStrongest at the mouth and in the throat
FishingWork the leading edge as it advances
Upstream limitSet by river flow and tidal range
HazardStanding waves where the push meets outflow

The flood has a front

The push carries cold, salty, oxygenated water upstream under the lighter river water, and predatory fish often meet it at the leading edge. The decision is to be at the mouth before the push arrives, not after the table says the tide has turned. A flood tide does not raise the whole estuary at once. It enters through the mouth as a moving front, and the front separates the outgoing river water from the incoming sea water. Ahead of the front the current still runs seaward; behind it the current runs landward. The front is visible because the two water masses differ. Sea water is usually clearer and greener; river water is browner and fresher. Where they meet, the convergence collects foam and the surface texture changes. In a shallow inlet the front can be a line of small breaking waves. The front moves upstream with the tide, and its speed depends on the depth and the flow. In a deep channel it can travel several kilometres in an hour; in a shallow, braided estuary it may stall and reform around bars.

The salt wedge underneath

Sea water is denser than fresh water, so the incoming tide does not simply push the river back. It slides underneath, forming a wedge that thickens upstream and tapers to a point where the two flows balance. The interface between the wedge and the river is a density boundary. It can be sharp in a stratified estuary, with fresh water flowing out above and salt water flowing in below, or diffuse in a well-mixed estuary, where the two blend through the full depth. The position of the wedge moves with the tide and with river flow. On a large flood and a low river, the wedge can travel far upstream; on a small flood and a high river, it may barely enter the estuary. The upstream limit of salt is not the same as the upstream limit of the tide, and the two are often separated by many kilometres. The wedge stops where its advance balances the river. The dense layer moves upstream under a pressure gradient set by the density difference, and the river pushes back with its own momentum. When the river speeds up, the interface arrests and is pushed seaward while the tide is still rising. That balance sets the upstream limit of salt. A thermometer cast that finds no cold layer above the limit is confirming the balance rather than a failed measurement.

Where the push shows

The surface expression is strongest at the mouth and weakest upstream. At the mouth the push meets the outflow, and the shear produces a line of foam, a colour change and often a band of choppy water. Upstream, the surface may show little. The wedge is underneath, and the only clue is a change in temperature or clarity at depth. A thermometer lowered through the water column can find the interface as a sharp drop of a degree or more. Temperature is often the most reliable instrument. In summer the incoming sea water is cooler than the river, and the wedge shows as a cold layer near the bottom. In winter the reverse can occur, with the sea warmer than the river, and the wedge shows as a warm layer. Either way, the change is abrupt enough to find with a hand thermometer on a weighted line. Salinity is the definitive measurement but it needs a meter. A refractometer reading from a sample collected at depth is enough to establish whether the wedge is present and how far upstream it has reached. That single number is more useful than a surface colour change, because the surface can be misleading when the wind mixes the top metre. Birds and baitfish often mark the push. Terns working a line, or bait scattering at the surface, can indicate the leading edge before the colour change is obvious. The behaviour of the water itself, a sudden flattening or a line of small ripples, is another cue. The front's speed is measurable without instruments. Pick two fixed objects on the same bank, a post and a moored buoy 200 m apart, and time the foam line from one to the other. Two hundred metres in four minutes is 50 m per minute, or 3 km per hour, which puts the front at a mark 1.5 km upstream in half an hour. Repeat the timing on the next flood at the same state of tide; the difference between runs is the effect of river flow and wind, and it is the number to carry to the next mark.

Fishing the leading edge

The leading edge is the productive zone because it carries new water, new oxygen and often new bait. Fish that have been sitting in the turbid river water move to meet it, and the first hour of the flood can be the best of the day. Position ahead of the push. A boat that waits at the mouth and drifts with the incoming water stays with the edge; a boat that arrives after the push has passed is behind it and fishing water that has already been worked. Work the edge rather than the clear water behind it. Predators often hold just inside the turbid side, where they can see into the clear water without being seen. A lure presented along the boundary, at the depth of the interface, is in the right place.

Shallow and deep marks

A shallow mark responds quickly to the push. The water arrives, covers the flat and brings bait with it, and fish move onto the newly covered ground within minutes. The window is short and the position is precise. A deep mark responds more slowly. The wedge moves along the bottom, and the surface may show nothing for an hour. The fish may be at the interface, which can be several metres down, and a surface lure will miss them. The depth of the interface is the key variable. In a stratified estuary it can be found with a sounder or a thermometer, and the lure should run just above it. In a mixed estuary there is no interface, and the fish are distributed through the water column. There is also a first-push effect that is easy to miss. The initial surge often carries a pulse of cold, clear water that is stronger than the steady flood that follows. Fish respond to the pulse and then settle, and the best fishing can be over within forty minutes of the front passing. A session planned for the whole flood can miss the only productive part. Turbidity changes behind the front as well. The incoming sea water is clearer, and the leading edge is where visibility improves. That is the opposite of the ebb, where the plume carries sediment out. On the flood the clear water arrives first and the turbid river water is pushed upstream, so the lower estuary clears as the tide rises.

Timing the push

The push does not arrive at low water. It arrives when the tide has turned at the mouth and the incoming water has had time to travel to the mark. At the mouth the lag may be minutes; ten kilometres upstream it can be two hours or more. The lag is the reason a tide table is a poor guide to the flood at an upstream mark. The table gives the time of low water at a station, which may be at the mouth, and the push at the mark can be well after it. A local observation, or a gauge pair, is the only reliable guide. The push also weakens as it travels. By the time it reaches the upper estuary, the front may have dissipated and the incoming water may be mixed through the column. The fishing at the leading edge is therefore best in the lower estuary, where the front is still coherent. Two gauges give a better estimate than one. If the outer gauge has turned and the inner gauge is still falling, the push is somewhere between them, and the difference between the two curves shows how fast it is travelling. That comparison is the same hydraulic logic that governs an inlet, applied along the estuary rather than across its mouth. The push also changes with the range. A spring tide drives a larger volume and a faster front; a neap may produce a weak intrusion that never reaches the middle estuary. A mark that fishes well on the spring push may see no push at all on the neap.

Safety at the front

The push meeting an outgoing river can produce standing waves at the mouth, especially on a spring tide with a high river. The waves are short, steep and unpredictable, and they can swamp a small boat. The push also carries debris from the lower estuary, and a boat running the edge at speed can hit a floating log. Keep a lookout ahead of the drift line, and avoid running the front in low light. In a narrow inlet the incoming jet can run at several knots, and a boat that is not positioned for it can be swept upstream or turned. The safe approach is to wait outside the mouth and enter behind the front, not in front of it.

Keeping a flood record

Write down the predicted low water, the time the colour change appeared, the time the current reversed at the mark, and the depth of the interface if one was found. After a few tides the log gives a local flood timetable. The log also shows whether the push is worth chasing. If the front dissipates within a kilometre of the mouth, the upstream marks will not see it. If it stays coherent for five kilometres, the lower estuary is the place to be, and the timing is worth the early start. Two numbers from the log expose the anomaly. Note the interval between the turn at the outer gauge and the colour change at the mark; when that interval doubles from its usual value, the river is running higher than the tide is strong, and the push will be shallow and short. A flood that brings no colour change at all is the clearest reading: the river is winning, and the mark fishes like the ebb until the catchment drains.

Sources

  1. Estuarine Circulation — Coastal Wiki · T2
  2. Tidal Inlet Dynamics — Coastal Wiki · T2
  3. Tides and Currents FAQ — NOAA Tides and Currents · T1
  4. Tidal Currents — NOAA National Ocean Service · T1