Key facts
| Fact | Detail |
|---|---|
| Fog threshold | Visibility below 1,000 metres |
| Dense fog | Visibility below 100 metres |
| Radiation-fog wind | Generally 5 knots or less |
| Advection-fog wind | 6 to 18 knots for a deeper bank |
| Radiation fog clearing | A few hours after sunrise |
| Shallow fog layer | Less than 2 metres deep |
| Sea fog duration | Several days in a persistent coastal spell |
Which fog type is forming
Three numbers name the type before you leave: air temperature, dew point and sea surface temperature. The decision is to launch short, wait for the sun, or stay ashore, and each type points to a different answer. Fog is visibility below 1,000 metres, and dense fog is visibility below 100 metres. A layer less than 2 metres deep counts as shallow fog. The type matters because each one clears by a different mechanism. Compare the air dew point with the sea surface temperature first. If the dew point sits above the water temperature, the air is already saturated at the temperature of the sea surface, and onshore flow condenses it into fog over the water. If the dew point sits well below the water temperature and the sky was clear overnight, the land cooled and radiation fog is the candidate. Wind speed narrows the list. Radiation fog forms in light wind, generally 5 knots or less, because stronger mixing spreads the cooling through a deeper layer and keeps the surface inversion from tightening. Advection fog needs turbulence to carry the cooling upward, and 6 to 18 knots supports a deeper bank. Wind direction decides where the fog goes. Onshore flow brings a sea bank to the beach. Offshore flow can leave the ramp clear while the outer water stays blind, which makes a dry launch site a poor indicator of conditions two miles out. The order of events on a foggy morning is consistent. Dew forms first on cold surfaces, then mist appears over wet ground, then the layer thickens until the far bank disappears. Fog is declared at 1,000 metres, but the practical loss of a shoreline starts earlier, when the next headland becomes a grey outline. Watch for that outline to fade and treat it as the first usable warning.
Advection fog: the sea surface sets the ceiling
Advection fog forms when warm, moist air moves horizontally over a colder surface and cools below its dew point. Over the sea the coldest layer sits directly on the water. Contact cooling chills the air at the surface, turbulence mixes that chill upward, and the lower layer reaches saturation. Cooling continues as the air travels, so a long fetch across a cold current or an upwelling band produces a thicker bank than a short crossing. This is the fog that forms in a steady onshore wind and covers a whole coastline. The controlling number is the gap between the air dew point and the sea surface temperature. A dew point above the water temperature means the air needs no further cooling to condense at the surface. A dew point a few degrees below it means the air must travel far enough over the cold water to close the gap. A cold upwelling band close to shore shortens that fetch and can produce a narrow, dense strip of fog along one beach while the next bay stays clear. Coastal fog of this type can cover the shore quickly when the wind comes in from the sea. Warm land erodes the bank from the shoreline inward, and cool land lets it stand. Sea fog of this type is often thick and persistent even in moderate wind, and a coastal spell can run for several days. It does not follow the sunrise rule, because the sea surface temperature changes far more slowly than the land temperature does. A sea bank arrives in steps rather than as a gradual dimming. Visibility drops from clear to about a mile, holds for several minutes, then drops again as the next parcel of cooled air crosses. The far headland disappears before the near shore. Watch the far headland, because its loss of detail is the first usable warning and it comes before the fog reaches the beach.
Radiation fog: land cooling under a clear sky
Radiation fog forms at night when the ground loses heat by radiation, the air in contact with it cools, and the moisture in that air condenses. Clear skies, light wind and enough low-level moisture are the ingredients. The ground cools fastest on a long night with no cloud, and the coldest air collects in hollows and valley floors. That is why fog fills low ground first and ridge tops stay clear. The same cooling over water is weak, because a water surface mixes and holds its temperature through the night. Wind above about 5 knots mixes the cooling through a deeper layer and delays saturation at the surface. A dead calm produces dew or a very shallow layer rather than a deep bank, because the cooling has no mechanism to spread upward. The fog drains downslope overnight and pools over a harbour or an estuary. Clearing follows solar heating: the ground warms, the inversion breaks, and the fog usually disperses a few hours after sunrise. Thick fog or a middle-level cloud deck slows that heating and pushes the clearing later. Radiation fog is a land phenomenon first. It can drift over the water, but its clock is set by ground temperature rather than by the sea. A clear night on the coast with a heavy dew and a dawn temperature close to the dew point is the setup. Fog inland with clear water offshore is the same event seen from two places, and the beach can stay fishable while the road to it is blind.
Steam fog and upslope fog: the local exceptions
Steam fog forms when cold air passes over warmer water and the evaporating water saturates the cold air above it. It appears as wisps and patches rather than a uniform bank, often on a cold morning after a hard freeze. In coastal areas a cool land breeze flowing across warm sea can make it extensive and lift it into low stratus. The signature is a plume that rises off the water and thins with height. A steam plume means the air is colder than the sea, which is a cold-season pattern. Upslope fog forms when wind forces air up a slope and the air cools as it rises. On a coast with a ridge behind the shore, cloud can sit on the ridge while the water stays clear, or the bank can feed down the slope toward the harbour. The signature is cloud on the high ground and a visible lower coast. Both types are local and both disappear when the temperature contrast or the wind direction changes. Neither type usually builds the wide, days-long bank of advection fog. A steam plume over one channel or a cap on one ridge is a local hazard. A short run to nearby structure is a different proposition from a long run through an open bay, and the size of the bank sets which one you are planning. A local cap is a reason to stay close; a county-wide bank is a reason to stay at the ramp.
The numbers to check before launch
The dew point is the temperature to which air must cool to reach saturation, and the dew point depression is the gap between air temperature and dew point. A depression of 1°C or 2°C with an onshore wind means the air is close to condensing and a cold water surface will finish the job. A depression of 8°C or 10°C means a long, cold fetch is needed, and fog is unlikely near the beach. Read the marine dew point rather than the air temperature alone. Visibility thresholds set the operational limit. Fog starts below 1,000 metres and dense fog below 100 metres. A boat running at 20 knots covers about 600 metres in a minute, which is six times the dense-fog visibility limit. At that speed the stopping distance exceeds the distance at which a mark becomes visible. Slow to the point where the visible distance is greater than the stopping distance, and treat an unmarked channel as closed. Wind direction decides whether the bank reaches your shore. Onshore flow advects fog onto the coast and holds it there. Offshore flow can clear the beach while the outer water stays blind. Land temperature sets the erosion rate: a warm afternoon erodes coastal fog from the shoreline inward, and a cool land surface lets it stand through the day. A cold sea with a warm, humid wind is the strongest signal of a persistent bank.
How the fog clears and how to use the window
Each type clears by a different route. Advection fog opens when the wind shifts, when a warmer air mass arrives, or when the land warms enough to erode the bank from the shore. Radiation fog opens with the sun. Steam fog opens when the air and water temperatures move closer together. A bank that lifts into low stratus has improved surface visibility without improving the ceiling, and the horizon can clear while the cloud base stays low. Watch three things: the distance to the horizon, the sharpness of a known mark, and the direction the fog is drifting. Fog drifting offshore is opening water near the beach even while the outer grounds stay blind. Fog drifting onshore is doing the opposite, and a patch of blue overhead is not a clearing. Note the time the first change appears and the time the mark returns. That interval is the local clearing rate for the morning. Use the first clear patch as a look, not as clearance. Launch into water you can navigate by visible marks, and extend the range only after the second and third marks appear on the same bearing. A window that opens for ten minutes and closes again is a bank lifting and settling, not a clearing trend. Keep the plan for the return unchanged until the horizon has stayed open for half an hour. Time the window from the wind, not from the clock. A shift from onshore to offshore is the most reliable clearing signal for a sea bank, and it shows first as a change in the drift of the fog rather than in the sky. When the drift reverses, the water near the beach opens within minutes, and the outer bank can remain solid for another hour. Night and dawn windows behave differently. Radiation fog is thinnest just after sunset and thickest near dawn, so an evening launch on a clear, calm night starts with better visibility than the return. An advection bank can do the reverse, thickening through the night as the land cools and holding until the wind shifts. Plan the return first on any session that will end after midnight.
When the type diagnosis fails
Warm-front fog: rain saturates the air ahead of a warm front, and fog forms without a cold sea or a clear night. Fog that lifts into stratus: surface visibility improves while the ceiling stays low. Sea-breeze onset: afternoon onshore flow can push a bank onto a beach at an hour when radiation fog cannot exist. Cold harbour surfaces: a shaded quay or a cold river outflow condenses the lowest layer while the open water stays clear. A wide dew point spread with fog present: spray, rain or a cold land surface is doing the cooling, and the sea temperature is not the control. Log the dew point spread, the wind direction and the sea temperature at the ramp at dawn for three mornings. Add the time the first mark returns and the wind at that moment. Three entries are enough to separate a sun-driven clearing from a wind-driven one, and the pattern that repeats fits the shoreline better than a generic forecast sentence.
Related reading
Sea fog and the navigation rules Planning for visibility at night Onshore and offshore wind
Sources
- What is fog? — Met Office · T1
- Aviation services — Fog — Australian Bureau of Meteorology · T1
- National Weather Service Glossary — Fog — NOAA National Weather Service · T1
- National Weather Service Glossary — Dew Point and Dew Point Depression — NOAA National Weather Service · T1