Katabatic Drainage: Cold Air Running Down to the Sea

On a clear night beside a fjord, the water can be glassy at the boat and ruffled a hundred metres away. The ruffle comes from a valley mouth, it runs in one direction, and it stops as abruptly as it started. That is katabatic drainage: cold air that has pooled on high ground, become dense, and started to slide downhill toward the sea.

wind and weather
Cover illustration: Katabatic Drainage: Cold Air Running Down to the Sea

Key facts

QuestionAnswer
DriverAir cooled over high ground becomes denser and drains
Typical speed10 to 30 km/h
Layer depth10 to 100 m
TimingNight and early morning, usually
Sky conditionClear, which allows strong radiational cooling
Synoptic windLight, otherwise the drainage is overridden
TerrainSlopes, glaciers, fjords, valley mouths
Daytime counterpartAnabatic upslope flow
Main hazardSudden cold gust at a valley exit

Cold air on a slope

It is a local wind with a fixed geography, and on the right coast it decides where a boat can sit and where a line can be cast. Air in contact with a cold surface loses heat and becomes denser than the air around it. On a slope, that denser air has a downslope force acting on it, and if the slope is steep enough and the cooling strong enough, it begins to move. The process is strongest where the surface is cold and the sky is clear. Clear skies allow the ground to radiate heat away efficiently, so the air above it cools quickly after sunset. Snow and ice accelerate the effect, because a melting or frozen surface keeps the adjacent air near freezing even when the airmass above is warmer. The result is a shallow layer of cold air, typically 10 to 100 m deep, moving downhill at 10 to 30 km/h. The layer is much thinner than the surrounding airmass, which is why the wind it produces can be strong at the surface and absent a hundred metres up.

The outflow exits at valley mouths

On a simple slope the drainage spreads downhill and disperses. In mountainous terrain it collects in gullies and valleys, and the valleys funnel it toward the coast. Where a valley meets the sea, the accumulated flow exits as a concentrated jet. That geometry explains the local character of the wind. It comes from one direction, defined by the valley, and it appears at the same place every time the conditions are right. Two beaches a kilometre apart can be on opposite sides of the outflow, one in the jet and one in its lee. The jet also carries cold air offshore, so the water temperature at the surface near the mouth can be lower than the water a few hundred metres away. The temperature difference is small, but it is a useful confirmation that the flow is drainage rather than a synoptic wind.

When it meets the background wind

Katabatic drainage does not exist in isolation. It is superimposed on whatever larger-scale wind is blowing, and the result depends on the two directions. If the synoptic wind is light and blows in roughly the same direction as the drainage, the two reinforce and the outflow is stronger and more persistent. If the synoptic wind opposes the drainage, the cold air may stall at the valley mouth or be deflected along the coast. A strong synoptic wind overrides the drainage entirely. The large-scale pressure gradient is much stronger than the local density difference, and the valley outflow disappears. That is why a katabatic wind is a fair-weather, light-wind phenomenon: it needs the background flow to be weak enough to let it show. The transition between the two regimes can be abrupt. A synoptic wind that drops after sunset can allow the drainage to establish within an hour, and the wind at the valley mouth can appear without any change in the weather map.

Glacier and fjord coasts

The classic setting is a fjord with steep walls and glaciers at the head. The glaciers keep the adjacent air cold, the walls provide the slope, and the water provides a place for the cold air to spread out. In that setting the drainage often runs down-glacier and then down-fjord, following the axis of the water. The wind at the head of the fjord can be steady and cold while the outer fjord is calm. Boats anchored near the head feel it; boats a few kilometres out do not. The same pattern appears on any high-latitude coast with steep terrain and cold water. The wind is not necessarily strong in absolute terms, but it is cold, it is persistent, and it arrives from a direction that the regional forecast may not show.

The morning decision

For an angler, the drainage matters most in the hours around dawn, when it is at its strongest and when a shore or boat session is being planned. Check the sky first. A clear night with light wind is the setup for drainage; a cloudy or windy night is not. Check the temperature at a station near the valley mouth against a station away from it. A colder reading at the mouth confirms the outflow. Then choose the position. A mark directly in the outflow will be cold and windy, with a surface chop running offshore. A mark to one side, in the lee of the valley wall, will be sheltered and often calmer than the regional forecast suggests. For a boat, the concern is the sudden gust at the exit. A boat anchored in the outflow can swing or drag when the drainage pulses, and a small boat heading into it takes spray and loses speed. Stand off the axis, keep a way out, and expect the wind to drop as the sun rises and the slope begins to warm.

Slope, snow and sky set the strength

Three variables control how strong the drainage will be. Slope angle sets the downslope force. A steep slope produces a faster flow than a gentle one, and a cliff behind a beach produces a sharper outflow than a long, shallow valley. Surface temperature sets the density difference. Snow, ice and a recently cooled rock surface produce colder air than a warm, dry slope. That is why the same terrain produces a stronger drainage in winter than in summer. Sky cover sets the cooling rate. A clear sky allows the surface to radiate heat through the night, while cloud traps some of it and reduces the temperature drop. A partly cloudy night can produce a weaker and more intermittent flow.

Drainage air is not a gentle valley breeze

The daytime counterpart is the anabatic flow: air over a sunlit slope warms, becomes less dense and moves uphill. It is usually weaker and less organised than the night drainage, and it reverses the direction. The two are often confused with the land breeze. A land breeze is driven by the temperature difference between land and sea over a broad area; katabatic drainage is driven by cooling on a slope and is channelled by terrain. On a coast with hills, the two can combine, with the land breeze providing the general offshore drift and the drainage adding local pulses at the valley mouths. The practical difference is scale. A land breeze affects a stretch of coast; a katabatic outflow affects the area in front of one valley. If the wind is coming from a specific gap and the rest of the coast is calm, it is drainage.

Reading the outflow from the water

The surface shows where the jet runs. Look for a band of darker, ruffled water running offshore from a gap in the hills, with a sharper edge on each side. That edge is a wind line, and it often carries foam or weed because the converging surface flow collects material there. Inside the band the air is colder and the chop is steeper; outside it the water can be almost glassy. Sound is the second cue. Drainage moving through trees or around buildings at the valley mouth produces a steady rustle that carries to the shore before the wind arrives. On a still night that sound is the most reliable warning that the outflow has started, and it usually fades within an hour of sunrise.

What the outflow does to the fishing

The drainage changes the surface, not the fish. It pushes cold air and cold surface water offshore, flattens the water in its lee, and creates a wind line at the edge of the jet. Bait that has collected along the shore can be pushed offshore by the outflow, and the birds and surface activity follow the food. The edge of the jet, where the cold air meets the calmer water, is a natural place to look, because it is a convergence of surface material. The cold water itself is a consideration. A sudden pulse of cold surface water can shut down activity in a shallow bay, while the deeper water outside the jet stays stable. Fish the edge rather than the coldest water, and expect the pattern to change as the sun rises and the drainage weakens.

Measuring the outflow

You do not need a weather station to confirm that drainage air is running. You need two readings taken at the same time in two places. Carry a handheld anemometer to the valley mouth and read the wind at two metres above the water. Then compare it with the nearest coastal station, ideally five to ten kilometres away on open ground. If the valley site is three to five knots stronger and two to three degrees colder, the drainage is established. If the two sites agree, the valley is not draining; you are feeling the background wind. Without an anemometer, the same information is available from signs. Smoke from a chimney or a fire drifts downslope and out over the water. Flags and moored boats lie with their bows pointing seaward while the trees on the ridge are still. A bank of fog forms at the valley mouth and spills out in a slow, low tongue. Spider webs on a railing are loaded with dew on the downwind side. Timing follows a predictable curve. Drainage begins one to two hours after sunset as the slopes cool, strengthens through the night, and peaks in the two to four hours before dawn when the inversion is deepest. It collapses one to two hours after sunrise as the valley floor warms and the inversion breaks down. Cloud cover is the main modifier. An overcast night traps outgoing radiation, weakens the inversion and produces little drainage. A clear, calm night with snow cover produces the strongest flow, because snow radiates heat efficiently and keeps the surface cold.

Five assumptions to check

Assuming every offshore night wind is a land breeze. Expecting a katabatic outflow on a cloudy or windy night. Treating the regional wind forecast as the wind at a valley mouth. Anchoring in the axis of a known outflow. Waiting for the drainage to stop before deciding where to sit.

Sources

  1. Prevailing Winds (Flight Environment training page) — National Weather Service · T1
  2. Diurnal Slope Flows (ATSC 113, Learning Goal 6b) — University of British Columbia · T2
  3. Local Winds (ATSC 113, Learning Goal 10a) — University of British Columbia · T2