Mixed Tides Bring Unequal Highs and Single-High Days

The tide table lists two high waters, one at 06:12 and one at 18:40, with heights that differ by more than half a metre. A plan that treats high water as a single daily event will be wrong for one of those windows. The first question is which regime the station records — semidiurnal, mixed or diurnal — and the second is which of the two highs the mark can use.

tides
Cover illustration: Mixed Tides Bring Unequal Highs and Single-High Days

Key facts

Key factDetail
Mixed tideTwo highs and two lows, unequal
Diurnal tideOne high and one low
Cause of inequalityLunar declination
Station recordThe only reliable source of tide type

Three regimes, one station

Both answers come from the station's own predicted curve, not from a regional chart or a port across the headland. A semidiurnal coast gives two highs and two lows of broadly similar height. A mixed coast also gives two of each, but the pair is lopsided: one high runs noticeably higher than the other, and the same is true of the lows. A diurnal coast gives one high and one low in a day, so there is no second high to compare. The distinction is a property of the station, not of the sea area on a map. Two ports inside the same bay can record different types when the bay has a narrow entrance, a shallow sill or a strong resonance. | Regime | Highs and lows per day | Successive highs | |---|---|---| | Semidiurnal | Two highs, two lows | Similar height | | Mixed | Two highs, two lows | Clearly unequal | | Diurnal | One high, one low | No second high | | Decided by | The station record | Not an offshore or neighbouring-port table |

Why the moon's declination splits the pair

The inequality is astronomical before it is local. The moon's orbit is inclined about 5° to the ecliptic, and the ecliptic is inclined 23.5° to the equator. As the moon circles the earth once a month, it crosses the equator twice and reaches maximum angular distance north and south of it in between. When the moon is near the equator, its tide-generating envelope is nearly symmetric about the equator, and the two daily highs come out close in height. As declination increases, the envelope tilts. One of the two bulges passes closer to the observer's latitude than the other, and the corresponding high runs higher. The cycle repeats on the moon's 29.53-day synodic month. A mark that gives two usable windows this week can give one usable window two weeks later, with no change in the mark itself. A note that says "the second high works" is therefore incomplete without the date and the two predicted heights beside it. Distance modulates the same effect. The moon's distance from the earth varies by about 31,000 miles over its elliptical orbit, and the tide-raising force changes with the inverse cube of that distance. Perigee produces above-average ranges; apogee, roughly two weeks later, produces below-average ones. The earth's own orbit adds a smaller annual term: ranges are enhanced near perihelion, around 2 January, and reduced near aphelion, around 2 July. Spring and neap tides sit on top of this. At new and full moon the solar and lunar forces align and reinforce each other; at the quarters they act at right angles and partly cancel. Spring tides arrive roughly 36 to 48 hours after the syzygy, and the springs nearest the equinoxes run slightly larger than the rest. Four cycles — daily, monthly, perigean and seasonal — combine at every station. Moon phase alone does not tell you which high will be the bigger one.

Read the pair, then the interval

The interval from high water to the next high water is roughly 12 hours 25 minutes, but low water is not halfway between them. In an estuary or a shallow bay the flood can run four or five hours and the ebb seven or eight, or the reverse. The midpoint between two highs is a time, not a stage. Take a predicted day with a 4.2 m high at 06:12 and a 0.6 m low at 12:40. The fall is 3.6 m over 6 hours 28 minutes, an average of about 0.56 m per hour. If the mark needs 2.5 m of water, the level crosses that height well before the low, and the usable window closes earlier than a midpoint calculation suggests. The same arithmetic on the second high tells you whether the weaker window clears the mark at all. Read the two highs and the two lows together, in height and in time. A higher high that arrives late can still leave less usable water than a slightly lower high that arrives at a convenient stage of the current. The pair is the planning unit; a single "high water" line is not.

A regime can change inside one strait

Tide type can change over a distance short enough to cross in a small boat. Torres Strait is the standard example: the western side runs diurnal and the eastern side semidiurnal, and at some phases of the moon it is high water at one entrance while it is low water at the other. A table from one side describes the other side badly. Amphidromic systems produce the same trap on a smaller scale. Around an amphidromic point the tidal range falls to near zero and the crest rotates around the node, so stations on opposite sides of the node run in opposite phase. In Britain the spring range reaches 12.2 m at Avonmouth and only 1.9 m at Lowestoft, and high water arrives hours apart at Cromer, Lowestoft and Aldeburgh, three towns on the same stretch of coast. The operational rule follows directly: use the station inside the same water body as the mark, then check that its record shows the pattern you actually see. If the station sits outside the inlet, behind a sill or on the far side of a passage, it may be describing a different regime with the same name.

Currents keep their own clock

A mixed tide sets two different water levels, and the current that moves with it does not necessarily peak at either high. Slack water and maximum flood or ebb follow one of three patterns, and the pattern is local. In a standing-wave system, slack arrives close to high and low water and the strongest current runs near mid-tide. In a progressive-wave system, the strongest current arrives near high and low water and slack falls between them. In a hydraulic system, the current is driven by the height difference between two connected water bodies, so it peaks when that difference is greatest and goes slack when the two levels match. The three cases produce opposite timing, so a generic "last two hours of the flood" rule can be wrong at a given inlet. Tide predictions give heights and times; current predictions give maximum speed and slack, and the two are produced separately because the relationship differs at every station. Read the current station, not the tide table, when the plan depends on when the water moves rather than how deep it is. On a mixed day the stronger high usually drives the larger volume of water, and the corresponding flood is the one with more force behind it. Local geometry decides where the flow is constricted, and that can reverse the ranking at a particular mark. The weaker high still delivers a usable stage on a mark that needs depth rather than flow.

Planning a mixed day

1. Compare the two highs before fixing a start time. Put the main session on the higher high when the mark needs water over a sill, a flat or a bar. 2. Give the weaker high a different job. A drop-off, a channel edge or a pier deck that stays usable can produce a clean session on the weaker high without the shallow approach. 3. Check both lows. A mixed day often pairs a very low low with a moderate one. A low-water access route can close earlier on the deeper low. 4. Build the window from the curve. Use the predicted times and heights around the chosen high, then find when the falling level crosses the depth the mark needs. 5. Re-check the date. The stronger high switches within a week or two as declination changes, so last month's note does not transfer.

Where the two-high plan breaks

The plan fails on a genuinely diurnal coast, where one high and one low are the whole day. It adds nothing when the two highs are nearly equal, because the day is behaving as semidiurnal and there is no strong and weak window to separate. It fails when the table comes from a different water body and the predicted inequality never appears on the shore. The subtler failure is timing. A mixed day can give a high that is higher in height but later than expected, and the mark's usable depth depends on the combination. Checking height alone can put you on the water after it has already drained. Read height and time as a pair, and read both highs before committing to a tide.

What to record

Log the date, the station identifier, both highs and both lows with times and heights, which window produced fish, and the water state at the mark. After a month the log shows whether the second high is consistently weaker at that station or whether the pattern moved with declination.

Sources

  1. Our Restless Tides, Chapter 4: Variations in the Range of the Tides: Tidal Inequalities — NOAA Tides & Currents · T1
  2. Torres Strait (Hammond Rock) Queensland — Australian Bureau of Meteorology · T1
  3. All about tides — National Tidal and Sea Level Facility (National Oceanography Centre) · T2
  4. Frequently Asked Questions: What is the relationship between tides and tidal currents? — NOAA Tides & Currents · T1