Key facts
| Quantity | Value |
|---|---|
| Perigee to perigee | About 27.55 days |
| Spring-neap beat | About 14.77 days |
| New or full moon near perigee | Roughly 6 to 8 times a year |
| Perigee distance | About 356,500 km |
| Apogee distance | About 406,700 km |
| High-water difference, moderate range | Of order 0.3 m |
| High-water difference, 30 ft range | 3 ft or more |
| Flooding | Requires weather as well as alignment |
Two clocks running at once
That matters because the highest water of the year is usually a perigean spring, and the days either side of it are when low routes close, slipways flood and currents run hardest. Being able to name the window in advance is the difference between planning a trip and reacting to one. The Moon's orbit around Earth is an ellipse, so the Earth-Moon distance changes through the month. Perigee is the closest point and apogee the farthest. Perigee recurs on the anomalistic month, which averages 27.55 days, and apogee follows roughly 14 days later. The spring-neap cycle is driven by a different geometry: the alignment of Sun, Moon and Earth. Spring tides occur at new and full moon, neap tides at the quarters, and the beat between successive springs is about 14.77 days. The two periods are close but never identical. Two spring cycles take 29.54 days, while one perigee cycle takes 27.55 days. The two-day difference accumulates, so the phase of perigee relative to new or full moon drifts continuously. That drift is the whole story.
Why distance changes the tide so much
Tidal force weakens with the cube of separation, so a small change in distance produces a large change in pull. At perigee the Moon is about 356,500 km away; at apogee it is about 406,700 km. The ratio is 1.14, and cubing it gives about 1.48. The astronomical pull at perigee is therefore roughly half again what it is at apogee. The ocean does not respond linearly, which is why the observed difference at high water is smaller than the force ratio suggests. Local resonance, basin shape and friction all reshape the response. In a moderate-range harbour the perigean high water sits of order 0.3 m above the apogean spring; in a large-range harbour the difference is much bigger. The published comparison is more than 1 ft between the perigean and apogean phases at high water. Where the range exceeds 30 ft, as at Anchorage, the gap between the phases can reach 3 ft or more. In a 2 ft harbour the equivalent is a few centimetres. The percentage can match while the absolute height does not, which is why a headline from one coast means nothing on another.
How often the clocks agree
If perigee returned every 14.77 days, every spring tide would be perigean. It does not. The alignment occurs when a new or full moon falls close to perigee, and that happens roughly 6 to 8 times a year. The figure is a practical summary of a beat, not a calendar. The dates shift year to year, and the alignments cluster: a coast can go months without a perigean spring and then see two or three within a season. Two reasons drive the clustering. The lunar orbit's orientation relative to the Sun changes slowly, and the perigee distance itself varies from one anomalistic month to the next, so some perigees are closer than others. The drift is easy to picture. Perigee returns about two days earlier than the spring cycle does, so each month the perigee falls a little later relative to new or full moon. An alignment that sits one day behind the phase in January sits three days behind by March and has lost most of its strength by May. It then arrives on the other side of the phase, still strong, and the pattern repeats with the direction reversed. Over a year the alignments walk through the calendar rather than locking to a season. Clustering has a practical consequence. If a road or a slipway floods on one perigean spring, it is likely to flood again on the next alignment if the seasonal sea level is still high. The vulnerable period is the cluster, not the individual date.
Reading a window correctly
Four checks turn the alignment into a usable forecast. First, find the perigee date and the new or full moon date. A coincidence within about a day is the strong configuration. The further apart the two dates, the smaller the perigean contribution, because the spring alignment is already moving away from the perigee. Second, check the perigee distance. Almanacs publish the distance in kilometres as well as the date, and the smallest figures of the year mark the closest approaches. A perigee at 357,000 km and one at 370,000 km are not equivalent, even though both fall inside the same broad window. Third, check the seasonal baseline. In many harbours the mean level follows an annual curve set by water temperature, the prevailing winds and river flow. When that curve is near its crest, a perigean alignment starts from a raised platform, and the total can beat the year's highest astronomical tide calculated at average conditions. That is why the highest water of the year is often not the highest astronomical tide of the year. Fourth, check the weather. The astronomy supplies the baseline; wind and pressure decide whether the baseline becomes an event. Onshore gales and deep low-pressure centres routinely add tens of centimetres, and that margin can convert an exceptional astronomical high into a flood.
Perigean is not a forecast
A perigean spring tide does not guarantee flooding, and it does not guarantee that the water will reach a particular mark. It guarantees a higher astronomical baseline than an ordinary spring, and nothing more. Official tide predictions already include the effect. The astronomical positions of the Sun and Moon are computed for each prediction, so the perigean contribution is embedded in the numbers rather than added as a separate correction. Adding a perigean allowance on top of an official prediction double-counts it. That is the most common technical error with these tides: treating the alignment as a correction rather than as something already modelled. The second most common is applying the absolute difference from a large-range station to a small-range one.
What it changes on the water
For fishing, the perigean spring matters through access, current and drift. The extra range opens or closes low-water routes, and the stronger mid-tide flow changes how a bait travels and where a drift ends. On sand, a perigean low exposes more of the bar system, which is useful for reading but also means a longer walk to the water and a faster return of the flood. On rock, the extra height puts the waterline higher on the face, and the swell that accompanies a big spring can make the base unfishable even when the wind is light. In an estuary, the larger prism scours the throat harder and pushes the salt wedge farther upstream on the flood. The current at the mouth can run well above its neap strength, which changes the weight needed and the time available to cross. For a boat, the same alignment means stronger currents and a larger tidal stream. A drift line calibrated on a neap will be left behind, and an anchor set for a neap will drag on the spring. The day of the alignment is not the only useful day. High water stands near its peak for roughly an hour either side of the predicted time on a large-range coast, and that plateau is when a shallow route is most workable. On the days immediately after the alignment, the range shrinks by a small amount but the tide arrives later, which can move the window from dawn to mid-morning. A session planned around the plateau rather than the instant of high water gets more usable time from the same alignment. The extra height also extends the reachable ground. On a flat shore a perigean high lets fish move onto ground they cannot reach on an ordinary tide, and a mark that is dry for most of the month becomes fishable for an hour or two. That window is short, and it is worth planning as its own session rather than folding it into a general trip.
Comparing perigean springs across years
The gap between two perigean springs can reach several tens of centimetres, since neither the perigee distance nor the seasonal level repeats exactly. A comparison that ignores both attributes the difference to the site rather than to the sky. The useful record is a table with the date, the perigee distance, the phase date, the predicted high at the local gauge and the observed waterline. After a few years the table identifies the combination behind the mark's highest water, and that combination is the one to plan around.
Mistakes that survive for years
Assuming every spring tide is perigean. Treating the 6 to 8 per year figure as a fixed monthly schedule. Using a king tide headline as a local height forecast. Ignoring the seasonal mean sea level term. Assuming a perigean spring must cause flooding. Adding a separate perigean correction to an official prediction. Comparing absolute differences between coasts with different ranges. Treating two perigean springs as equivalent without checking the perigee distance.
A short planning routine
Once a year, list the perigee and phase dates and mark the close coincidences. For each, note the perigee distance and the predicted high at the nearest gauge. Rank the windows by predicted height rather than by the word "king" in a news story. Then, as each window approaches, check the wind and pressure forecast. If an onshore gale is forecast, treat the window as a flood risk for access and for anything stored at the waterline. If calm weather is forecast, treat it as a spring tide with a higher baseline and plan the session accordingly. The alignment is predictable a decade ahead. The storm that turns it into a flood is not. Planning uses the first and checks the second.
Related reading: king tides, the nodal cycle, tide-calendar planning.
Sources
- What is a Perigean Spring Tide? — NOAA Ocean Service · T1
- Tides — NOAA JetStream · T1
- What is a Spring Tide? — NOAA Ocean Service · T1