Key facts
| Question | Answer |
|---|---|
| Spring trigger | New or full moon, sun and moon nearly in line |
| Neap trigger | First or third quarter, sun and moon at right angles |
| Spring range | Highs higher and lows lower than average |
| Neap range | Highs lower and lows higher than average |
| Frequency | Each type twice per lunar month, year-round |
| Range measure | Height difference between consecutive high and low |
| Local lag | The largest range can arrive a day or two after syzygy |
| Perigean spring | A spring near lunar perigee runs higher than an apogean one |
What alignment actually changes
On a coast with a two-metre swing the difference between spring and neap can open a ledge that is normally underwater, while on a sea with a thirty-centimetre swing the same labels change almost nothing. Pick the shore from the predicted heights at the station nearest the mark, then check the return route against the same curve. At new and full moon the sun, earth and moon lie close to a straight line. The solar and lunar tide-generating forces then add, the ocean bulges a little more, and the range widens. Seven days later, at the quarters, the two forces act at right angles and partially cancel, so the range contracts. The mechanism is gravitational and it is not seasonal. Spring tides occur twice each lunar month throughout the year, and the name comes from the old sense of the tide "springing forth", not from the season. Treat the word as a label for alignment. The timing is not exact. The ocean takes time to respond, and the various constituents that make up the tide do not peak together, so the largest range often arrives a day or two after the astronomical alignment. A moon-phase symbol is therefore a rough forecast of direction, not a date for the biggest water.
How big the swing is at one gauge
NOAA's tide explainer gives a worked example from Santa Barbara, California, for May 2019. The greatest range came around new and full moons, at 6.27 ft and 7.18 ft. The smallest came at the first and last quarters, at 4.72 ft and 3.16 ft. In round terms, about seven feet at the springs and about three at the neaps. Those four numbers are one station in one month. They show what "larger" and "smaller" mean in feet, and they also show why the phase label alone is insufficient: the two spring peaks differ by almost a foot, and the two neap troughs differ by more than a foot and a half. A plan that treats all springs as equal is already wrong at that gauge. The size of the swing scales with the local range. A coast with a 1.5 m mean range might see 1.2 m at neaps and 1.9 m at springs. A resonant bay with a 10 m mean range might see 8 m and 13 m. The ratio is not universal, and no conversion factor transfers from one basin to another.
Perigean springs and the distance term
Not every spring carries the same water. Lunar distance changes through the month, from roughly 356,000 km at closest approach to roughly 407,000 km at the far point of the orbit, and the tide-raising force falls off steeply as that distance grows. A syzygy near the close approach therefore lifts high water above the value of a syzygy near the far point. NOAA labels the first a perigean spring tide and reports that its highs are commonly more than a foot above an apogean spring, with differences of 3 ft or more at Anchorage, where the range exceeds 30 ft. The figure is a prompt to check the perigee date, not a rule that transfers to every coast. On a shallow flat the extra few tens of centimetres decide whether a channel is walkable; on a steep rock shore they change nothing. Read the predicted height at the mark and compare it with the height the route needs. The operational consequence is specific. A perigean spring can overtop a ledge that a normal spring leaves exposed, and it can open a bar that a normal spring barely drains. It also puts more water on a narrow dry strip, which is the case where a spring high plus onshore wind closes a return route.
Match the shore to the range
The shore type decides which end of the cycle helps. A low-water bar or rock ledge wants a big low. A spring low exposes more of the structure and lengthens the working window, provided the walk-in and the return are checked against the same curve. The water comes back faster on a big range, so the window opens earlier and closes harder. A high-water ledge, slipway or pier deck wants enough depth over a sill. A neap high is lower than a spring high, so the mark may not fish at all. Compare the predicted height with the sill depth rather than with the word "neap", because a perigean neap can beat an apogean spring. A beach with a narrow dry strip is a margin question. A spring high plus swell removes more dry ground, and a neap high leaves more room. The range tells you the water level; it says nothing about the swell, which can add setup and run-up on top. An estuary with a shallow mouth needs the inner gauge. The range at the mouth and the range at the inner station can differ by a large factor, and the mouth is passable or not by the water actually inside it. On a mixed semidiurnal coast the two daily lows are not equal. The lower low exposes the bar; the higher low leaves it covered, and the two daily highs differ in the same way. A plan keyed to "low water" without naming which low is wrong on half the days. Read the morning and evening lows as separate events, put the low-water session on the lower one, and keep the higher low for a mark that needs water over a sill.
The return route is the constraint
A big low is only useful if the route back remains open. On a wide flat the water can retreat a kilometre and return in less time than it took to walk out, because the same volume passes through the same channels and the inner flat fills last. Work the return from the predicted curve, not from the time of low water. Find the height at which the route closes, read the time when the rising tide reaches that height, and subtract a margin that matches the walk. A spring low that exposes a new area also returns faster at the end, and the last thirty minutes can be the difference between a wet walk and a cut-off. The same arithmetic applies to a boat. A spring low can leave a launch ramp usable at the start and dry at the finish, and a neap high can leave a shallow entrance passable when the chart suggests otherwise.
When the phase label misleads
The label fails in four common situations. The local range may be so small that the spring-neap difference never changes a decision. The local peak may be offset from the phase date by a day or two. Weather may add or subtract more water than the phase does. And the phase may be read at a different station from the one that governs the mark. Sustained onshore wind and low pressure raise the water above the astronomical prediction, while offshore wind and high pressure lower it. A spring high in calm air and a spring high in a 25-knot onshore wind are not the same water level, and the second can close a route the table says is open. The wrong-station error is the most common. A phase is regional; a range is station-specific. Mixing an ocean-entrance range with an inner-estuary plan combines two different water bodies and produces a number that belongs to neither.
Neaps are not the worse choice
Neap tides get treated as the poor relation, but they solve specific problems. The smaller range keeps upper ledges and high platforms fishable, slows the current at constricted marks, and reduces the amount of debris and weed moving on the flood. On a mark where the fish sit close to structure, a softer flow can be an advantage. Neaps also make access predictable. A route that is marginal on a spring is comfortable on a neap, and a launch that dries at spring low may stay wet. The trade is a smaller working window on low-water structure and often less water movement to position fish. The decision is therefore not spring versus neap in the abstract. It is which shore type the day's range suits, and whether the access works at both ends of the session. Currents reinforce the choice. A spring tide moves roughly twice the volume of a neap in the same time, so an inlet that is manageable at neap can be unsafe at spring. The same doubling changes how a lure fishes: a heavier jig is needed to reach the bottom, a drift covers ground faster, and a soft-plastic presentation that worked in a gentle flow starts spinning. Neap water is easier to read and easier to fish slowly, which is why flatfish and fussy feeders often prefer it. Water clarity follows the range as well. A big spring stirs the shallows and lifts sediment from flats and channels, while a neap leaves the water clearer. On a sand flat the difference can be a metre of visibility, and that changes whether a fish will take a lure at distance or needs it placed close to cover.
Planning a fortnight rather than a day
Tide ranges move in a two-week rhythm, so a mark can be scheduled rather than gambled on. Look at the predicted ranges for the coming fortnight, identify the four or five days that suit the shore type, and put the trip on one of them. That is more reliable than picking a weekend and hoping the phase cooperates. For a low-water mark, the best days usually fall one or two days after new or full moon, when the range is near its local maximum but the weather has not necessarily turned. For a high-water mark, the neap days around the quarters give the most stable access, because the range is small and the height changes slowly from day to day. The schedule also exposes the trap of the monthly average. A month with one very large perigean spring and three ordinary ones is not an average month at the mark; it is a month with one extraordinary set of tides and several normal ones. Plan against the specific day's curve. The chosen day still needs three checks. First, read the predicted high and low at the gauge nearest the mark for the date, and compute the range. Do not use a phase symbol or a monthly average. Second, compare that range with the depth the mark needs. If the mark needs water over a sill, check the predicted high against the sill height. If it needs exposure, check the predicted low against the level at which the structure dries. Third, check the access at both ends. The route in and the route out must work at the predicted heights, with a margin for wind setup and for the faster return on a big range. If either end fails, change the mark rather than the plan.
Sources
- What are spring and neap tides? — NOAA National Ocean Service · T1
- Tides (JetStream) — NOAA · T1
- What are tides? — NOAA National Ocean Service · T1
- Our Restless Tides, Chapter 5: Local Heights and Times — NOAA Tides and Currents · T1
- What is a perigean spring tide? — NOAA National Ocean Service · T1