Key facts
| Fact | Detail |
|---|---|
| Global model grid spacing | about 10 km |
| Regional UK model spacing | about 1.5 km |
| Resolution needed for sea-breeze detail | about 2 km |
| Minimum gust spread | 10 knots |
| Gust speed that affects balance | 30 to 40 mph |
| Example at a sea-loch entrance | Force 3 to 4 becoming Force 6 |
| Headland width below one global grid cell | 2 km |
Why a 10 km grid cannot see a 2 km headland
Local terrain funnelling is the part of the wind that a regional chart hides. Start with the constriction on the map, confirm it on the water, and add the difference to the forecast before you choose a rod. Numerical weather prediction divides the atmosphere into a grid and solves the equations of motion for each cell. The global model runs at roughly 10 km spacing. The regional UK model runs near 1.5 km. Neither draws a 2 km headland as a shape. At 10 km the headland sits inside a single cell, so its effect is folded into an average surface roughness instead of being resolved as flow around an obstacle. The result is a forecast that is right for the region and wrong for the entrance. Sea-breeze detail needs about 2 km resolution before it appears reliably, and the same limit applies to terrain-driven acceleration at headlands and loch mouths. Below that scale the model smooths away the feature that decides your day. That mismatch is the reason a local correction exists. Treat the marine forecast as background flow. Then add a local correction from the chart. Find the constriction between your mark and the reported wind direction, judge how much the cross-section narrows, and expect the speed to rise where the flow is forced through. A 15-knot forecast with a steep gully upwind is a 20-knot day at the mouth. The correction is local judgement. Two similar gullies behave differently because one is aligned with the wind and the other is not. Models also differ in how they handle land surface friction, so the same headland shows up differently in two forecast products. A model represents sub-grid terrain through a roughness parameter, and that parameter is tuned for an average landscape. It cannot know that your gully points north-east while the next one points south. Flow from land to sea adds a second correction. Friction is greater over land, so wind leaving the coast speeds up as it crosses the shoreline, and the speed change bends it slightly through the Coriolis effect. An offshore day at the beach can be lighter than the same flow a kilometre outside. A forecast of Force 3 to 4 can arrive as Force 6 at a Scottish sea-loch entrance, with a local direction that has little to do with the synoptic south-west.
What counts as a funnel on the chart
Funnelling needs a constriction and flow that enters it. The term is channeled high winds: air forced through constricted passages in mountains or between tall buildings, local in extent and strong within a well-defined area. Four shapes do most of the work on the coast. A ridge saddle or col between two summits accelerates flow crossing the ridge line. A gully or river valley aligned with the wind channels it downslope to the shore. A harbour mouth or sea-loch entrance narrows the cross-section and speeds the flow at the entrance. A gap between tall waterfront buildings does the same at street scale. Alignment decides whether the funnel works at all. Wind blowing along the axis of a gully accelerates through it; wind crossing the axis barely enters. Look at the forecast direction, then at the chart, and ask whether the two line up. A funnel drawn on the map counts only when the flow points into it. Height matters as well. Wind strengthens with height and accelerates over ridge tops, so a mark on the exposed side of a ridge runs stronger than the beach below it. The sheltered side of the same ridge gives a lee, and that is usually the fishable water. Distance matters too: the strongest acceleration sits close to the constriction and weakens downwind as the flow spreads and mixes.
The acceleration signature on the water
On the water a funnel has a visible edge. Where the flow is constricted, the surface changes from a lightly rippled patch to a darker, rougher band. Sailors call the boundary a wind line, and it marks the transition between background wind and accelerated flow. Watch the whitecaps. In a funnel they appear first in a narrow lane and spread outward as the wind builds. The lane sits where the flow leaves the constriction, usually a few hundred metres off the mouth rather than directly in it. Whitecaps that stop at a hard line with smooth water beyond are showing you the edge of the jet. Watch the direction. Wind bending around a headland arrives at the shore at an angle to the regional forecast, and the bend is strongest close to the obstacle. A 30-degree difference between the chart arrow and the surface drift is common at a corner. Watch the gusts. A funnel delivers pulses rather than a steady increase. Flags snap and relax, the rod load changes between casts, and dark patches travel downwind across the surface. Those patches are the peaks you have to rig for. Take a bearing on two fixed points and check the drift every few minutes. When the drift line changes while the forecast stays the same, terrain is steering the flow. Timing follows the sun. Funnels fed by sea-breeze or upslope flow are strongest in the afternoon, when the land is warmest and the onshore gradient is deepest. Funnels fed by cold-air drainage are strongest after dark and around dawn, which is why a flat morning turns gusty before the sun clears the ridge.
Gust spread at the funnel mouth
A gust is a brief peak inside the average wind speed. The working definition uses a difference of at least 10 knots between peak and lull. The ratio of peak to sustained is the gust factor, and on a funnel day that ratio rises because the same constriction that accelerates the mean flow also breaks it into pulses. The arithmetic is worth doing before you leave. A 15-knot average with a 10-knot spread contains 25-knot moments. Those moments lift a fly line off the water, blow a lure off its arc and push a drifting boat sideways faster than the angler can correct. Plan tackle for the peak. One step heavier in rod and line, a shorter cast, and a low rod tip keep the presentation under the worst of it. In a boat, reduce speed before the entrance and keep the bow into the steepest water. Set a turnaround number before the session. Gusts over 30 or 40 mph affect balance on exposed ground, and a wet rock ledge with a rod in hand offers less support than a mountain path. Treat 30 mph as the point to leave, not to start thinking about it. Write the number on the console before you leave the ramp. A funnel adds spread even when the printed average barely moves. That is why the forecast reads 15 and the water behaves like 25. Kayaks feel the spread differently. A paddler cannot trim a hull or add power the way a console driver can, so the peak decides whether the boat holds its line. Plan the drift so gusts push toward open water rather than onto a lee shore.
Picking the fishable side on a funnel day
Downwind of every constriction there is a sheltered strip. Flow bleeds around its edges and reverses in a small eddy, so the calm has a boundary rather than a soft fade. Use the shelter deliberately. Anchor or stand inside the lee, cast to the edge and keep the boat inside the line. The strongest wind sits at the mouth and along the exposed flank, so the water worth fishing is usually the first 50 metres inside the calm. Temperature is a useful tell. Sheltered air is not mixed as deeply as the air in the exposed flow, so the two sides of the shadow line differ by a degree or two. On a cold morning the difference is obvious on your face; on a warm afternoon it is easy to miss. Look for where weed and foam collect. The same convergence that marks the wind edge concentrates floating material, and bait follows it. Fish the line where the slick ends and the riffle begins. Crossing the mouth is the decision that matters most. Time it for slack water, when the sea is shorter and the boat has room to correct. Cross with the swell and wind aligned rather than against either. Keep speed up but not planing, because a boat at displacement speed meets a steep crest without launching. Check the far side before committing. Whitecaps right across the mouth mean no sheltered lane and no gain from the crossing. A dark line confined to the entrance means the acceleration is local and the water beyond is workable. If the far side looks worse, turn back while you still have a clear line and the ebb behind you.
What makes a funnel run harder
Three variables decide how hard a funnel runs on a given day. Stability comes first. A strong temperature inversion, with warmer air above cooler surface air, suppresses vertical mixing. Cold air drains through the gap as a shallow layer and accelerates with little dilution. The funnel runs harder and the shadow beside it is sharper. Obstacle height and spacing come second. A continuous ridge forces flow over the top and around the ends. A row of towers with gaps produces a different pattern: acceleration between the buildings, a wake behind each block, and turbulence that reaches the water. The two do not give the same wind at the same forecast value. Background wind direction comes third. Wind aligned with the gap accelerates through it. A cross-flow hardly enters, and the funnel stays quiet even when the regional forecast is strong. Tide and current modify the result. Wind against a tidal stream shortens and steepens the sea even when the wind number is unchanged, and an entrance that is manageable at slack water becomes steep an hour into the ebb. Boat type sets the limit. A kayak and a 7-metre centre console meet the same gust with different margins, and the smaller craft feels the funnel first because it has less mass to punch through the chop.
Building a local correction for the mark
A correction is useful only when written down. Stand at the mark, note the time and the surface state, then compare both with the forecast for the nearest marine zone. The gap between them is the local correction for that wind direction. Carry a handheld anemometer if you have one. Read the wind at chest height on the exposed side, then again in the lee, and record both. Two readings per session build a table faster than memory does. Use fixed cues when no instrument is available. A flag on a mast, the angle of a moored boat, the size of the whitecaps and the speed of the surface drift all scale with wind. Photograph the cues at 10, 15 and 20 knots and the image set becomes your gauge. Apply the correction to your own threshold. When your limit for a kayak is 12 knots and the funnel adds 7, the ceiling at that mark is a 5-knot forecast. The arithmetic is local and personal. Review the table at the end of the season. Marks that consistently run 5 knots above forecast belong on the exposed list, whatever the chart says. Wind direction, tide stage and stability should sit beside each entry, because the correction changes with them. A correction that never holds means the constriction you picked is not the one doing the work.
Related reading
Wind speed thresholds for shore and boat Gusts versus sustained wind Onshore versus offshore wind
Sources
- Glossary: Channeled High Winds — NOAA National Weather Service · T1
- Mountain safety: wind — Met Office · T1
- Why the Forecast Is Always Wrong (near land) — VAKA Field Notes · T4
- Local Winds (ATSC 113) — University of British Columbia · T2