Wind Setup Makes the Tide Run High or Low

The table says low water at 15:40, and the plan needs the last hour of the ebb to reach the mark. At 15:40 the water is still over the lower step. The wind has been blowing onshore since morning and the pressure has been falling all day. Nothing is wrong with the prediction.

tides
Cover illustration: Wind Setup Makes the Tide Run High or Low

Key facts

TermDirection of effectWhat controls it
Wind stressPiles surface water downwindSpeed squared, fetch, duration, depth
PressureLifts water under a lowAbout 1 cm per hPa
Coast shapeConcentrates or spreads the pileConcavity, bay width, entrance
SetdownRemoves water from a lee shoreOffshore wind, same physics reversed
Basin typeAmplifies in enclosed waterLimited escape routes for the water
Spring tideAdds to the surgePhase of the astronomical tide

A slope held by wind

It described the astronomical tide; the atmosphere has added a second term, and on this coast the second term is larger than the difference between one tide and the next. Wind setup and its opposite, setdown, are the part of the water level that the table never contains. Wind does not lift water; it drags the surface layer downwind until the water surface tilts enough to push it back. The tilt is the setup. At equilibrium the downwind slope of the surface balances the wind stress, and the slope is proportional to the stress divided by depth: the same wind produces a steeper slope in shallow water because there is less water to share the pile. That single relationship explains most of what an angler observes. A long, shallow bay with the wind blowing straight up it can gain tens of centimetres at the head and lose the same amount at the mouth. A deep, open coast gains far less for the same wind, because the water can move vertically without a large surface slope. The depth of the basin is as important as the wind speed, and it is the reason two beaches under the same forecast can differ by half a metre. The slope also takes time to establish. Water has to be transported across the basin, and the transport is slow. A squall that lasts twenty minutes moves very little; a wind that holds its direction for six hours moves a great deal. The response time scales with the size of the basin, so a small lagoon fills and empties quickly while a large bay takes most of a day to reach its maximum tilt.

Wind speed, fetch and duration

Setup grows roughly with the square of wind speed. Doubling the wind from 15 to 30 knots multiplies the stress by about four, so the pile at the head of the bay is roughly four times as deep, other things being equal. This is why a fresh breeze is a nuisance and a gale is a planning problem: the effect is not linear and it arrives suddenly at the top of the wind range. Fetch is the uninterrupted stretch of water that the wind crosses before it reaches the shore. Two kilometres of open water cannot build the same pile as twenty kilometres, because at the downwind end the water has only been driven a short way. Banks and headlands cut the run, so an estuary offers little room for a pile to grow even in a strong blow; a wide bay or lagoon gives the wind kilometres of run and the setup becomes the dominant term. Duration and fetch interact. A strong wind over a short fetch for a long time reaches an equilibrium set by the fetch; a strong wind over a long fetch for a short time is still filling. The practical reading is to check both the wind forecast and the geometry of the water in front of you, then ask whether the wind has had time to do its work.

Coast shape concentrates the water

A concave coast gathers water that would otherwise spread along the shore. A bay with a narrow entrance is the extreme case: water pushed into the bay cannot escape sideways, so the level rises until the pressure gradient forces it back out through the entrance. The result is a local rise that exceeds the rise on the adjacent open coast. The approach angle matters too. A wind blowing perpendicular to the coast drives the maximum water ashore. A wind blowing obliquely spreads the stress along the shoreline and produces a smaller pile at any one point. A wind blowing parallel to the coast produces little setup at all, although it can still generate a strong alongshore current and a confused sea. For a fishing plan, the geometry to identify is the direction that puts the wind straight up the axis of the bay or estuary. That is the direction that closes a low-water route early, floods a slipway and pushes dirty water into the usual clear mark. The same wind on the opposite shore is offshore, and the level there falls.

The pressure term

A low-pressure centre allows the sea surface to bulge upward, and the rise is close to 1 cm for every hectopascal the pressure is below the surrounding value. A deep low 30 hPa below its surroundings lifts the water about 30 cm before any wind effect is counted. The response is not instant. The ocean takes hours to adjust to a moving pressure field, so a fast-moving depression may pass before the water has fully risen, while a slow-moving one lets the surface keep pace. In a shallow bay the adjustment is quicker than in deep water, and the local geometry can amplify the result. Pressure rarely acts alone. The same low that lowers the pressure also carries the strongest winds, and the two terms usually peak together. A 30 hPa deficit with a gale behind it is not a 30 cm event; it is the pressure rise plus a wind setup that can be several times larger.

Setdown is the same physics reversed

When the wind blows offshore, it pushes surface water away from the coast and the level falls below the astronomical prediction. The mechanism is identical to setup, only the sign changes. Setdown of 30 to 50 cm is common on a lee shore in a strong offshore wind, and in shallow enclosed water it can be larger. Setdown changes a plan in the opposite direction from setup. A shallow channel that is normally navigable can become too thin for a boat's draft. A ramp that usually reaches the water can end above it. A low-water mark that is normally covered can stand dry, which sounds convenient until you notice that the same wind is exposing soft mud and pushing the clear surface water offshore. Setdown also has a biological side. Persistent offshore wind drives surface water away and draws deeper water up to replace it, so a lee shore can turn cold and clear while the windward shore turns warm and dirty. That is a real change in fishing conditions, not just a change in depth, and it is one of the reasons the two sides of a bay fish differently on the same day.

Spring tide plus gale

The dangerous combination is a spring high tide, a sustained onshore wind and a deep low arriving together. The astronomical high supplies the base level, the pressure adds its few tens of centimetres, and the wind adds the largest term. The total can overtop defences, flood a causeway hours before the predicted high, and make a low-water mark fishable only briefly. The timing of the surge peak relative to the tide matters as much as its size. A surge that peaks at high water adds its full height to the highest tide of the month. The same surge peaking at low water lifts a low tide toward mid-tide, which changes the fishing but does not flood anything. Forecast agencies publish surge as a difference from the predicted tide for exactly this reason: the two curves have to be added at the same moment. The reverse combination is a spring low with setdown. The water can be lower than any chart datum suggests, which exposes structure and concentrates fish, but it can also strand a boat and turn a familiar channel into a maze of bars.

Where wind is the main tide

On coasts with a small astronomical range, wind setup is not a correction; it is the tide. The Baltic, much of the Mediterranean, the Black Sea and large lagoons show water-level changes driven mainly by wind and pressure rather than by the moon. In the extreme, a shallow enclosed basin can tilt by a metre or more under a sustained gale, and the level at the downwind end can stay high for days. Enclosed basins also oscillate. A wind that piles water at one end and then drops leaves the surface tilted; the water sloshes back and forth at the basin's natural period, a seiche, which can persist for hours after the weather has changed. The period depends on the length and depth of the basin, and in a long lake or a narrow bay it can be comparable to the time between fishing sessions. A mark that was deep at noon can be shallow by evening with no change in the wind. The angling consequence is that the tide table is nearly useless in these waters and the wind forecast becomes the primary document. Direction, speed and duration tell you which end of the basin will be high, and the pressure trend tells you whether the whole basin is being lifted or pressed down.

Reading the day

Start with the wind direction relative to the shoreline at your mark, not the wind direction at the airport. A wind that is onshore at the head of a bay can be alongshore at the mouth, and the two ends will behave differently. Maps and satellite imagery make the geometry obvious; a wind arrow on a forecast page does not. Then estimate the run. Measure how much open water lies between the mark and the upwind shore along the wind axis. Hundreds of metres barely register; tens of kilometres can move the level by tens of centimetres. If the run is broken by a headland, the pile at the mark is smaller, but the headland itself may shed an eddy that changes the local current. Then check duration. A wind that has been blowing since dawn has had time to fill the bay; a wind that started an hour ago has not. The forecast should be read as a time series, not a single afternoon value. Finally, compare the prediction with a local gauge if one exists. The difference between the observed level and the predicted tide is the sum of the meteorological terms at that moment. Once you have seen that difference on a few windy days, you have a local calibration that no generic table can supply.

Decision rules

For a low-water route, assume the route closes earlier than the table suggests whenever the wind is onshore and sustained. The setup lifts the water over the shallowest section before the predicted tide reaches it, and the same wind may delay the drain afterwards. For a boat, check the draft against the lowest level expected during the session, not the level at launch. A falling tide plus setdown can leave a boat high on a bar within hours. For a mark that depends on a stage, remember that the stage refers to the astronomical tide. A setup can make a predicted low fish like a mid tide, and a setdown can make a predicted high fish like a mid tide. The name on the table describes the moon's contribution, not the water in front of you. On a calm day with a shore-parallel wind and a steady barometer, none of this applies. The table is the best available estimate and a small margin is enough. Adding a surge allowance on a windless day produces a plan that is wrong in the other direction.

Mistakes with wind and tide

Reading the tide table as an observed water level. Using the wind at a distant airport instead of the wind at the mark. Ignoring fetch and duration and looking only at wind speed. Forgetting that shallow water amplifies setup. Assuming a bay rises at the same rate as the open coast beside it. Treating setdown as harmless when it can strand a boat. Adding a surge margin on a calm, offshore-wind day. Overlooking the seiche that continues after the wind drops.

Editorial note

- UK Met Office, "Storm surge": https://www.metoffice.gov.uk/weather/learn-about/weather/types-of-weather/storms/storm-surge - UCAR Center for Science Education, "What Causes Storm Surge?": https://scied.ucar.edu/learning-zone/storms/what-causes-storm-surge - NOAA National Ocean Service, "Tides and Water Levels": https://oceanservice.noaa.gov/education/tutorial_tides/

Sources

  1. Storm surge — UK Met Office · T1
  2. What Causes Storm Surge? — UCAR Center for Science Education · T2
  3. Tides and Water Levels — NOAA National Ocean Service · T1