Key facts
| Item | Figure |
|---|---|
| Structure | Doubled line through the eye, overhand knot, loop over the tackle |
| Doubled section | 6–12 in (15–30 cm) |
| Tie time | Under 1 minute |
| Best line | Braid |
| Hook eye | Must pass two strands |
| Lure | Whole item must pass the loop |
| Measured result | 79.08 percent of 20 lb (9 kg) braid |
| Raw braid break | 41.45 lb (18.8 kg) |
| Not for | Joining two lines |
Why a doubled line changes the load path
It fails as a design, not as a tying mistake, when the eye will not take two strands or the lure will not pass through the loop. The checks below separate a seated Palomar from a knot that only looks finished. A Palomar is built around a bight, not a single tag. The line doubles through the eye, an overhand knot traps the doubled section, and the loop that remains is passed over the hook or lure. When load arrives, the eye sits inside the loop and the overhand knot closes against it. The doubled strands share the pull, so each carries roughly half the tension, and the eye never sees a single line bending sharply around wire. The eye becomes a toggle held inside a closed loop of line. The slip argument follows from the geometry. For the knot to fail by slipping, the whole structure has to loosen and travel back over the object it holds. No tag can creep through a coil stack because the tag is locked inside the overhand knot. That makes the Palomar stable at rest: a knot that is dressed correctly stays dressed when the line goes slack, and it does not need a running start to seat. The cost of the design is that everything scales with the object. The eye must accept two strands, the loop must swallow the whole item, and the doubled section must be long enough to tie an overhand knot with room to spare. Those three conditions are geometric, and no amount of tying skill changes them. A knot that ignores one of them fails at the first test.
The tying sequence, move by move
Double 6 to 12 in (15 to 30 cm) of line. The doubled section becomes the loop, the overhand knot and the short tag in one piece, so a section that is too short forces the overhand knot to form at the eye where there is no room to work. A longer section is easier to handle and costs nothing but a few inches of leader. Push the doubled bight through the eye. On a snug eye, pass the tag through first and bring it back through again to create the same doubled section. The trick buys room on an eye that is merely tight, and it does nothing for an eye that will not take two strands at any angle. Wet the tag before threading it on braid; a dry tag frays. Tie a loose overhand knot with the doubled line and leave the hook hanging below it. Open the loop and take it over the point, the barb, the bend and any split ring. The loop has to clear the entire item before the pull begins. A loop that stops at the barb will not dress into a Palomar, and pulling harder only tightens the overhand knot in the wrong place. Wet the knot, then draw the standing line and the tag in opposite directions. The overhand knot should close directly above the eye, with the two strands parallel and the loop snug around the eye or ring. Trim after the knot is seated. On braid, leave a short tag rather than cutting flush, because a flush cut can let the overhand knot shed its outer turns.
What the 2015 break test measured
The measured braid figure, based on 2015 test work run on an IGFA Instron machine, was 79.08 percent for a double-loop Palomar. The line was 20 lb (9 kg) PowerPro, and the same line broke at 41.45 lb (18.8 kg) on its own. The knot therefore kept most of a very strong line while giving up roughly a fifth of its measured strength. Other Palomar entries, tied with the traditional single loop, finished lower. The 100-percent label, based on 2019 instruction practice, is shorthand for a knot with no deliberate weak point, not a measured result. Read the two together and the useful expectation is this: on braid the Palomar is one of the better terminal knots, and it is still a knot, with a break point below the line's own. A fifth is a real margin, not a rounding error. The test also fixes the scope. One line, one machine and one set of tied samples do not rank the knot on 8 lb (3.6 kg) fluorocarbon or 50 lb (23 kg) nylon. The percentage travels with the line, the eye and the operator's hands, not with the knot name alone. The figure is a benchmark for one combination, not a target for every outfit.
The eye and the lure set the limits
Two strands through the eye is a diameter problem, and it is decided before any knot is tied. A small trout hook with a fine wire eye, a micro swivel or a heavy leader can each close the gap. Test the fit dry: fold the line, pinch the bight and push it through. If the bight needs force, the eye is too small for a Palomar on that line, and the answer is a single-strand knot rather than a longer fight at the hook. The tag-first workaround buys a little room on a snug eye. It changes nothing on an eye that is genuinely too small. Forcing a doubled line through a tight eye damages the coating before the knot is seated, and a damaged coating is where braid fails first. A hook that will not take the bight without force is the wrong hook for this knot. Eye quality matters alongside eye size. A stamped eye with a sharp seam or a chipped plating edge cuts doubled line under load, and the damage shows as a clean break at the eye rather than at the knot. Slide a thumbnail around the eye's inner edge before tying on an unfamiliar hook, and reject any eye that catches. The check takes a second and prevents a lost fish. Wire diameter matters as much as the opening. A heavy-gauge hook with a generous eye can still pinch two strands of light braid, because the strands flatten against a narrow slot rather than passing through a round hole. Look at the eye from the side before tying; a slot that is wider than it is tall is a poor fit for doubled line. The loop has to travel over the entire lure, which rules out most treble-hook plugs. A three-treble minnow with a long lip is awkward on a calm deck and close to hopeless in wind with cold hands. Single hooks, jig heads, swivels and rings pass easily, and those are the shapes the Palomar is built for. The attachment decides the knot more than the species does. The workaround is not to force the loop but to change the attachment. Tie an Improved Clinch or a Uni to the eye, or add a snap and tie to the snap, which lets the lure hang free. If the presentation needs a loop for action, a loop knot does that job better than any snug terminal knot. A snap also speeds a lure change. Lure size also affects the dress. A heavy jig swinging on a short doubled section pulls the overhand knot off centre before it seats, and the loop ends up bearing on one side of the eye. Support the lure while the knot tightens, or tie with the lure hanging over the edge of the boat, clear of the gunwale. A low rod tip helps as well.
Braid, nylon and fluorocarbon
Braid is the home case. The doubled structure grips where a stack of single coils would slide, the knot stays compact around the eye, and the lack of stretch means the join does not loosen when the line relaxes. Thin, slick braid is the version that needs the Double Palomar: one extra pass of the loop through the overhand knot before it goes over the tackle. The coating decides how much grip survives the first casts. Nylon is forgiving. The line stretches, the doubled section conforms, and a standard Palomar usually dresses cleanly. The check is that the two strands stay parallel near the eye. Nylon memory can roll them over each other if the knot is tightened in one fast pull, so slow down at the point where the loop closes. Wet nylon too; water lowers friction long enough for the strands to align. Fluorocarbon is stiffer, denser and more heat sensitive. It needs saliva before the final cinch, a slower pull and a close look at the bend radius at the eye. If the line kinks or turns cloudy while seating, cut the knot off. A dry pull on stiff fluorocarbon is the fastest way to turn a strong knot into a weak one.
Seating checks and failure modes
A seated Palomar has the overhand knot sitting directly above the eye, the two strands parallel and uncrossed, and the loop tight against the eye or ring. The tag points back along the standing line. Anything else is a knot that has not dressed, and pulling harder will not fix the geometry. Cut it off and start with a fresh bight. A dressed knot also enters the tip without a click. The common failures are mechanical. The loop stops at the barb. The overhand knot is tight before the loop goes over the tackle. The strands cross under the eye. The knot is pulled dry. The tag is cut flush on braid. Each one produces a knot that looks approximately right and fails at a fraction of the line's strength. A hurried knot usually shows two of these at once. Retie rather than repair. A Palomar cannot be re-dressed after it has been pulled hard, because the overhand knot has already locked the strands in whatever position they held. Cut above the eye, inspect the line for a flat spot, and start again with a new doubled section and a wet cinch. A fresh bight costs a few inches of line and removes the doubt.
Where the Palomar sits among terminal knots
The Palomar is the default when the tackle can pass through a loop and the line is braid. The Improved Clinch takes over when the eye is small, the lure is too bulky, or the leader is stiff enough that a doubled loop misbehaves. Those two knots cover most terminal work. Match the knot to the eye and the lure before matching it to the fish. The Palomar is not a line-to-line knot. Braid to leader belongs to the FG or the Double Uni, and a Palomar tied between two lines is a knot looking for an eye. The measured 79 percent result is also line-specific: a knot that wins on 20 lb (9 kg) braid does not automatically win on light fluorocarbon or heavy nylon. As of 2026, it remains the manufacturer's pick for braided main line. The practical test is a steady pull on the actual line and hook, done before the outfit goes in the water. Wet the knot, load it until the loop is hard against the eye, and look at the strands. If they are parallel and the overhand knot sits above the eye, the knot is ready. If anything has moved, cut it and tie again. That pull uses your line, your hook and your hands.
Related reading
The single-strand alternative for small eyes and bulky lures is the Improved Clinch. For line-to-line work, see the FG knot and the Double Uni. Whether two strands fit is set by hook-eye and wire sizing.
Sources
- How to Tie a Palomar Knot for Braid, Mono & Fluoro — Cast & Spear · T3
- How to Tie a Palomar Knot — Outdoor Life · T3
- How to Tie the Palomar Knot — Salt Water Sportsman · T3
- Winning Knots from Sport Fishing's Third Reader Knot Challenge — Sport Fishing · T3
- Fishing Knots 101 — Berkley · T3