Jig Coromandel's Channel Island With 200 g at Tide Turn

Channel Island is a small rock in a large piece of water, and that is the whole reason it fishes. Deep water surrounds it and fast current runs past it, so bait and predators are concentrated in a narrow band rather than spread across a bay. The fishing is not complicated; the timing is.

new zealandDifficulty 4/5
Cover illustration: Jig Coromandel's Channel Island With 200 g at Tide Turn
Targetskingfish, snapper
Wateropen-water, reef, channel
Regionsnz
Seasonspring, summer, autumn
Methodsjigging, boat fishing, lure fishing

Key facts

SignalReading
Snapper minimum30 cm
Snapper daily bag7
Kingfish minimum75 cm
Kingfish daily bag3
Combined finfish bag20
Channel depthup to 65 m
Snapper jig80-100 g
Kingfish jigabout 200 g
Wind limit10 knots or less
Best windowlast 2 hours of the outgoing tide

The limits first

The Hauraki Gulf and Coromandel sit inside the Auckland East SNA1 area, which stretches from North Cape down to Cape Runaway and reaches 200 nautical miles offshore. Snapper carry a 7-fish daily limit at a 30 cm minimum. Kingfish carry a 3-fish limit at 75 cm. Both sit inside the 20-fish combined finfish bag that applies across the whole Auckland and Kermadec area. That matters at Channel Island because the two species come from the same drift. A morning of jigging can fill the snapper allowance before the kingfish turn up, and the sub-limits are the ones that bind: the 20-fish total is not reached before the individual allowances are used. Knowing which limit stops the session is more useful than knowing the total. The numbers also set the release policy. A 15 kg snapper is a breeding female that may be several decades old, and snapper can live for 60 years. At 75 cm a kingfish is roughly four years of age and has probably not spawned yet. Keep the smaller fish for the table, photograph the big ones and put them back. The bag allows three kingfish; it does not require them.

Deep water and low foul

The stretch between Channel Island and Great Barrier Island is the best big-snapper lure ground in the region. The local charter description, current as of 2026, singles out Channel Island for the concentration of fish, and the reason is the bottom. The channel reaches about 65 m, and much of the productive ground is not dramatic reef at all. It is low foul — rock and weed that stand only 3 or 4 m off the sea floor — and broad banks that rise about 5 m over a large area. Those modest structures hold the biggest fish. A tall pinnacle draws schools of small fish and a crowd of anglers, but a gentle rise in 50 m of water gives a big snapper an edge to sit against without exposing it to the current. Working a jig along that edge is a different exercise from dropping onto a marked rock, and it depends on the sounder rather than on a chart. There is also a bank about 5 km northwest of Channel Island that rises to 42 m. It does not appear on traditional charts but is visible on modern sonar charting. It is the kind of ground that rewards a slow, methodical drift: find the up-current edge, plot the school, then run the drift again. These depth and structure notes are based on a 2015 New Zealand Fishing News feature by lure designer Paul Senior, and the ground itself has not moved. What changes is the fishing pressure and the electronics: a modern sounder and sonar chart make the low foul and the banks far easier to find than they were a decade ago, which means the edge is found faster and fished harder.

Current is the whole game

The Colville Channel carries a lot of water, and the current is what concentrates the bait. It also decides whether the session works. When the flow is running hard, a jig of any sensible weight is swept away from the boat before it reaches the bottom, the line bellies, and contact with the lure disappears. The working window is the turn of the tide. Slack water does not stop the fish; it stops the drift long enough for a vertical presentation, with the rod tip over the lure and the jig falling on a semi-tight line. The fish are still holding on the structure they have used all tide, and for a short period they can be reached. The best part of the cycle is the last two hours of the outgoing tide. By then the water has been moving for hours, the bait is stacked against the up-current face, and the flow is beginning to ease. The incoming tide fishes as well, but the outgoing window is the one to plan a trip around. Wind has to run with the tide. A southwest wind on the outgoing tide and a northeast wind on the incoming tide both keep the boat and the drift moving in the same direction. Wind against tide stands the sea up in the channel and makes the drift unmanageable, and no amount of jig weight fixes it. The hard limit is about 10 knots of wind. Above that the drift runs too fast for a jig to work the bottom, and a drogue becomes essential rather than optional. A boat that cannot slow its drift is a boat that is trolling a jig, not jigging it.

Reading the bank

Big snapper sit on the up-current side of a bank. The current pushes bait up the slope, and the fish hold where the bottom starts to rise, facing into the flow. That is the edge to search, not the flat top and not the down-current side. The sounder has to be zoomed into the bottom 5 m. Most of the fish will be hard on the sea floor, and a sounder on its normal range shows a lump of bottom rather than the marks above it. On a bank that rises 5 m over hundreds of metres, the difference between fishing the edge and fishing the flat is the difference between a fish and a blank. When a school shows, plot it rather than dropping a single mark. Mark where the school starts, drift through it, mark where it ends, then repeat the run. Three or four passes turn a single blob on the screen into a shape with a leading edge, and the leading edge is where the drift should begin. Bird activity is a shortcut, not a substitute. Shearwaters working over a bank mean baitfish, and baitfish mean predators somewhere below, often kingfish as well as snapper. Use the birds to find the area, then use the sounder to find the fish.

Snapper tackle and the slow presentation

The snapper jig is an inchiku or a sliding lure of 80 to 100 g in orange-gold or green-red. Those weights are proven on this ground because they fall slowly enough to stay in the bottom few metres and light enough to be lifted without tearing the hook out of a soft mouth. The tackle does not need to be heavy. The fishing is over sand and low foul, so there is nothing to cut the line on. Braid of 20 lb or less with a 20 lb fluorocarbon leader lands big snapper consistently. A sliding lure needs a slightly heavier trace of about 30 lb because the leader comes into contact with the teeth more often. The rod is the part that matters most. A specialist slow-jig rod with a soft, bendy tip loads against a big snapper without pulling the hook, and it keeps the lure moving in short, controlled lifts. A stiff mechanical jigging rod fishes the lure too fast and too far off the bottom, which is the wrong presentation for snapper. The retrieve is slow: a short lift of the rod tip, a pause, then slacken off and let the lure sink. Most takes arrive while it is sinking, so keep the line between your fingers and watch for it to stop early. A tap that does not develop into weight is usually a small fish; a solid stop is the one to strike.

Kingfish on the pins

Kingfish use the same channel for a different reason. They hunt the current edges and the structure that breaks the flow, and they take a fast, heavy metal jig worked through the top of the rock. The working weight is about 200 g, and 400 g comes out when the current is running hard or the fish are deep. A mechanical jigging rod, a high-speed reel and braid in the 30 to 50 lb class are the tools. The jig is dropped to the bottom, ripped upward in long strokes and allowed to flutter back. Kingfish take on the lift and on the fall, and a fish that hits on the fall usually hooks itself against the weight of the jig. The first run is the test. A 25 kg kingfish heading for the shallow reef close to the island will cut a light leader on the rock in seconds, so the drag has to be set to turn the fish rather than merely slow it. Set it at roughly a third of the leader's rating and use the rod to apply pressure rather than locking down and hoping. Hooked fish make for the shallow reef close to the island. That is the moment the tackle is tested, and it is why the leader has to be checked after every fish. A frayed metre of fluorocarbon is a broken fish waiting to happen.

Drift, position and the second pass

Jigging from a drifting boat is a sequence of short, repeatable runs. Start up-current of the mark, drop the jig before the boat reaches the fish, and work the lure through the strike zone as the boat passes over. By the time the drift is finished, the boat is down-current and the jig is behind the fish. The drogue is what makes that possible. A boat drifting at two knots cannot fish a 100 g lure on the bottom; a boat drifting at half a knot can. Deploy the drogue before the first drop, not after the drift has already run away. When a drift produces a fish, repeat it exactly. Note the line-up on shore, the depth at the strike and the direction of the drift, and run the same pass again. Big snapper are not evenly spread across a bank; they sit in small, repeatable spots, and the second pass over a good spot is worth more than a new drift over fresh water.

Season and sea state

The season runs from the first warm water of spring to the first cold southerlies of winter. Bait moves inshore, both species settle onto the structure, and the fishing is at its most consistent. The biggest snapper schools gather on the banks in late summer and autumn, and kingfish are present through the same months. Winter still fishes, but the weather windows are shorter and the channel is more exposed. A cold southerly with an outgoing tide is the combination to avoid; a calm winter day with light wind and a neap tide can be excellent, because the current is manageable and the fish are still resident. The go or no-go call is about the sea state the boat can work in, not about the forecast alone. The island offers no lee, and the current does not stop for a boat that has travelled to get there. A marginal forecast in a channel with this much flow is a day spent fighting the drift instead of fishing it.

Handling and release

A kept snapper is killed at the head, bled and put into an ice slurry. Snapper flesh deteriorates quickly in warm air, and a fish that is chilled within minutes is a different product from one that has been in a bucket all morning. A big snapper that is going back needs to be handled properly. Support the body, keep the fish out of the air for as short a time as possible, and release it head-first into the current. A 15 kg fish held vertically by the jaw can be damaged internally, and a fish that has been on the deck for a photograph is a fish that may not survive. Kingfish are released the same way: alongside the boat, head into the current, held until they kick. A fish that has fought for several minutes is exhausted, and a careless release into a running tide is often a dead fish.

Mistakes

Jigging through a hard-running tide instead of waiting for slack. Fishing the down-current side of a bank instead of the up-current edge. Using a snapper-weight jig on a kingfish mark, or a 200 g knife jig for snapper. Running the sounder on its normal range and missing fish hard on the bottom. Drifting without a drogue and calling it jigging. Fishing a marginal forecast in a channel with no lee. Locking the drag on a kingfish heading for the reef. Keeping a big breeding snapper when a smaller fish would do.

Related reading

Regions index

Sources

  1. Auckland and Kermadec fishing rules — Ministry for Primary Industries, New Zealand · T1
  2. Offshore Adventures — Colville Channel and Great Barrier — Coromandel Fishing Charters · T3
  3. Gettin' jiggy with it! — Boating New Zealand · T3
  4. Jigging Lures NZ: Expert Guide — Action Outdoors · T3
  5. Jigging secrets for big snapper revealed — New Zealand Fishing News · T3