A 150 m sink-rate problem for offshore eging

Offshore eging fails on sink rate before it fails on squid. At 60–150 m a 3.5-gou shore egi spends five minutes falling and never taps bottom in current, so it fishes water the squid have already left. Weight, line diameter and bottom contact decide the session.

eging
Targetssquid
Wateroffshore
Regionseast-asia, mediterranean, australia
Methodseging
Quick answer

Offshore eging fails on sink rate first: use a 100–200 g deep egi on PE 1.0–1.5 with 3–5 kg of working drag, and abandon the drift above 1.2 kt.

A 100 g deep egi is a different tool from a shore egi

A standard 3.5-gou egi weighs about 18–20 g and falls at roughly 0.3 m/s in still water. That is fine in 3–8 m of harbour: the lure reaches the weed in half a minute and the angler works it with two or three sharp lifts. Put the same lure over 100 m and the arithmetic turns against you. At 0.3 m/s the fall alone takes 5.5 minutes, and any surface current sweeps the line into a bow long before the egi arrives. Most of the retrieve is then spent taking up slack rather than working the lure.

A deep eging lure is a different tool from a scaled-up shore lure. The 100–200 g bodies sold for 60–150 m fall at 1.0–1.5 m/s in still water, so 120 m takes 80–120 seconds. The trade is that the lure no longer darts; it drops almost vertically and responds to small lifts. Expect the hit on the fall or in the two-to-four-second pause after a lift; a hard twitch rarely draws one. Shimano and Daiwa both publish separate deep-egi ranges, and the sink-rate figures are maker numbers — check yours against a measured drop in 20 m before you trust the catalogue.

Squid do not sit on the bottom all day. In the 60–150 m range they typically hold close to structure during bright hours and rise 5–20 m at dusk, which changes what "bottom contact" is for. A lure that grinds the sand at noon may need to be worked 10 m up at last light. Keep the sounder on the same scale through the session and watch where the soft layer sits, rather than assuming the depth you found at 10 a.m. is the depth that matters at 6 p.m.

Weight needed to reach bottom in 60-150 m of current

Start with a weight band, then correct for current and line drag. In current under 0.5 kt, 80–120 g covers 60–80 m, 120–160 g covers 80–120 m and 160–220 g covers 120–150 m. For 0.8–1.0 kt at the surface, add 30–40 per cent, because the water pushes the line rather than the lure. A 120 g egi that works in a slack neap tide will hang at 30 m off the bottom on a spring ebb and catch nothing.

Run the geometry once. Drift 0.8 kt is 0.41 m/s. If the egi falls at 1.2 m/s, the line angle from vertical is arctan(0.41/1.2), about 19 degrees, and a 120 m drop ends roughly 41 m behind the boat. That is still workable if you dropped uptide. Push the drift to 1.3 kt (0.67 m/s) and the angle becomes 29 degrees, the egi lands about 80 m back, and bottom feel disappears on PE 1.5. Heavier weight, thinner line or a different tide is the fix; a bigger lift changes nothing.

Sinker-ahead rigs exist for deep water — a 60–100 g bank sinker on a breakaway clip ahead of a normal egi — and they will reach bottom when a 120 g egi cannot. They also change the fall from a glide into a nose-down drop, and the squid reaction is not the same. Use them when depth and current leave no choice; treat them as a fallback rather than a default.

Measure your own sink rate once per trip, because catalogue numbers assume fresh line and still water. Find 20 m of flat bottom, drop the egi with the spool free, and time from splash to the first slack. A 120 g lure that claims 1.2 m/s and takes 28 seconds is falling at 0.7 m/s, which tells you the line is too heavy, the current is stronger than it looks, or the lure is fouled with weed. That one test is worth more than an hour of blind counting.

A two-angler boat needs a weight split rather than two identical rods. Run the heavier egi on the angler fishing the deeper side of the drift and the lighter one on the shallow side, so one lure stays in contact when the other is already dragging. If both anglers fish the same weight, both lose bottom at the same moment and the boat learns nothing. Alternate the leads every third drop, since the outside line sees more current than the one under the transom.

Line diameter sets bottom contact at 100 m

PE 1.0 at 0.165 mm and PE 1.5 at 0.205 mm differ by 24 per cent in diameter and about 54 per cent in frontal area. At 100 m in 0.8 kt that difference is several metres of extra bow and a delayed feel on every lift. For 60–100 m, PE 1.0 with a 3 m, 12–14 lb fluorocarbon leader handles a 120–160 g deep egi and 2–4 kg of drag. For 120–150 m and 180–220 g, PE 1.2–1.5 and a 16–20 lb leader give more margin against chafe on the retrieve.

Rod and reel matter less than capacity and drag consistency. A 6 ft 6 in to 7 ft 6 in medium-light slow-jig blank with a 3000–4000 size reel holding 200 m of PE 1.0 is enough for the weights above. Set working drag at 3–5 kg: squid do not run, but a snag at 120 m with a locked spool costs a rod tip or a finger. The reel's line lay matters more than its top-end drag, because a loose retrieve at 100 m produces the overruns that end deep sessions.

Terminal connections deserve the same attention as diameter. A doubled braid joined with six to eight turns each way, tightened until the braid changes colour, and a 3 m leader joined with a 12–16 turn FG knot will pass through the guides without a tick. A bulky knot adds a small parachute at 100 m and will fail first under 4 kg of drag. Retie the leader after every third or fourth drop, and cut back to clean braid whenever the last metre feels stiff or furry.

Bottom contact without eyes on the egi

Count the fall, watch the line, and confirm with the sounder. With a measured sink rate of 1.2 m/s, 120 m is a 100-second count. Stop counting when the line goes slack or the rod tip springs back; that slack is the egi arriving, and the take comes a beat later. Let the egi sit for one or two seconds, then make two or three short lifts of 20–30 cm with a two-to-four-second pause between them. The squid follows the rise and takes on the fall, so a fast, continuous jig sequence mostly catches nothing and tangles the leader.

The sounder earns its place here. A bottom line that stays flat while the egi should be tapping means the lure is dragging behind the boat rather than tapping the reef. Mark the depth where the trace thickens or the bottom hardens, then repeat the drop on that contour. In 100–150 m, a 2 m difference in where the egi lands decides whether you are on sand or on the edge the squid are using, and the sonar is the only instrument that tells you before the lure does.

Squid marks are not the obvious arches that fish produce. On many units they appear as a soft, smeared layer a few metres off the bottom, sometimes merging with the bottom trace. If the layer sits 5–10 m up, set the egi to pass through it rather than bouncing the bottom: count to the layer, then work the lure in that band with longer pauses.

Wind and current rarely push the same way at the surface and at 100 m. A boat drifting with the wind while the deep water runs against it produces a lazy S in the line that reads like a bite and feels like bottom. When the two disagree, drop a weighted line or a sinker alone and watch which way it lays; the angle at depth tells you whether to reposition. Fishing across a shear catches less than moving 200 m to where the layers line up.

The drift speed that ends a deep session

Work a range of 0.5–1.5 kt of drift, dropping uptide and retrieving downtide. At the top of that range, the boat moves 0.77 m/s and a 120 m drop takes over two minutes, so the egi lands more than 90 m behind the transom. The angler still feels bottom on a tight line, but the lure planes instead of tapping and the hook-up rate collapses. My cut-off is a surface current above 1.2 kt or a line angle above 30 degrees; at that point I move to a shallower contour or wait for the turn.

Boat position is the other half. Which marks hold squid is a regional question, and the Okinawa squid eging guide covers that coastline in detail; once you have one, line up 20–40 m uptide of it, stop the boat, and let the drift carry the lure over the structure rather than trying to hold station with the motor. A slow, controlled drift keeps the egi vertical for the first 40–60 m of the fall. If two egis are lost to snags inside ten minutes, the drift is wrong for the depth; adding weight only makes the snag more expensive.

Tide stage changes the drift inside an hour. A 1.2 kt ebb at mid-tide can fall to 0.4 kt within 40 minutes of slack, which is the difference between fishing and waiting. Plan the deep drops around the two hours either side of the turn, and use the fast middle of the tide to check gear or move marks. In places where the current never drops below 1 kt, deep eging is a neap-tide game and the calendar matters more than the lure box.

Landing, icing and the failures that end a session early

The common failure is not a lack of squid but a lost hour to gear. A snag at 120 m with 4 kg of drag and a fast current usually takes the leader, sometimes the braid, and always the next ten minutes. Check the leader for abrasion after every second drop, cut back 30 cm when it feels rough, and keep a spare spool rigged. The second failure is ink on the deck: a landed squid that empties over the gunwale makes the working area unsafe and costs more time than the squid is worth.

Land them over the side with a hand or a soft net, keep them away from your face and clothes, and chill immediately. A slurry of one part ice to one part seawater at 0–2 °C holds quality for the run home; squid left in a dry box at 15 °C soften within a couple of hours. Do not stack warm squid on top of chilled ones, and rinse the deck before the next drop rather than after the next ten.

Log the drop rather than the catch. Depth, weight, drift direction, time of the tap and whether the hit came on the fall or the pause give you a repeatable pattern within two or three sessions. Squid fishing punishes memory: the productive contour often moves 10–20 m with the tide, and the only way to find it again is to write down where it was when the taps started.

Deep eging is also a fuel decision. Running 20 miles for a 90-minute slack window in 120 m costs more than most bags are worth, so pick marks within 8–12 miles of the ramp and fish the tide you actually have. Two shorter sessions on consecutive neaps usually beat one long day fighting a spring tide, and they give you the second look at the contour that the first trip could not finish.

Bottom contact is the method

If the egi is not tapping within 10 seconds of the count, you are fishing the bow in the line rather than the reef. Change weight, change line, or change tide.

Short version

  • Below 60 m, use a purpose-built 100–200 g deep egi; a 3.5-gou shore lure never reaches bottom in current.
  • Weight bands before correction: 80–120 g at 60–80 m, 120–160 g at 80–120 m, 160–220 g at 120–150 m, in current under 0.5 kt.
  • PE 1.0–1.5 and a 12–20 lb leader; keep working drag at 3–5 kg and check the leader every second drop.
  • Stop the session when surface current passes 1.2 kt or line angle passes 30 degrees; heavier weight will not fix a bad drift.

Common questions

Can I clip a 100 g sinker ahead of a normal shore egi?

It reaches bottom, but the fall becomes a nose-down drop and the glide that triggers squid disappears. Reserve it for a fallback at 100 m plus; a deep egi remains the working tool.

Do I need a dedicated deep eging rod?

A medium-light slow-jig blank of 6 ft 6 in to 7 ft 6 in rated to 200 g is enough. A shore egi rod rated to 40 g will not load 160 g safely.

Sources

  1. Cabanellas-Reboredo et al., Environmental drivers of small-scale squid distribution — ICES Journal of Marine Science · T1
  2. FAO Species Catalogue for Fishery Purposes No. 4: Cephalopods of the World — FAO · T1
  3. Deep Down Squid: deep eging tackle and sink rates — Daiwa Australia · T2
  4. Yamashita Egi Oh series: weight and sink-rate specifications — Yamaria Corporation · T2
  5. Offshore Jigging Tactics — Salt Water Sportsman · T3
Read the bottom before you choose a squid jig colour
Squid evenings are decided by sunset, moon and wind together
An Egi Size Number Is Not a Sink Rate
Squid Jig Sizes: The Number Is Also a Sink Rate