Lift 30–50 cm, then stop your hand for two to three seconds so the jig slides sideways on slack line; if the line angle passes 15°, add weight before you lengthen the pause.
Slack line separates slow pitch from a slow lift
Watch the rod tip of an angler who has been told that slow pitch means lifting slowly. The tip rises in a smooth arc, the jig rises with it, and the lure arrives at the boat like a sinker on a string. Nothing in that motion is mechanically wrong. It is simply a different technique wearing the same lure.
The weight-for-depth table is in the metal jig weight and fall guide, and the count-to-bottom routine is in vertical jigging basics. Both apply here. This page covers the part neither of them teaches: what the jig does in the two seconds after your hand stops.
A slow-pitch body is shaped to keep moving after the input ends. Daiwa's product page for the Saltiga Partir Jig Long credits a two-flat-face profile with a slide that continues on inertia once the line is stopped, and wing shapes on the flank with an unpredictable fall. That is design intent, but it describes the mechanism honestly. The jig is a small wing, and a wing only flies when the line is not fighting it.
Tension is what kills the slide. A tight line pulls the nose of the jig toward the rod, straightens the body, and turns the lure into an anchor being towed upward. A slack line lets the body fall back to horizontal, where the flat faces and the keel can generate sideways travel. In the water, sideways travel is the part a fish reads as a wounded baitfish. Vertical travel reads as a weight going up.
Salt Water Sportsman's slow-pitch guide, written from long experience on Florida and Gulf boats rather than from controlled trials, describes the same sequence: drop with light thumb pressure so the jig falls straight, release the pressure at depth so it flutters, then flick the rod and let it fall again without resistance. The lift is a small input. The fall is the presentation.
So the question is not how slowly you lift. It is how completely you get your hand off the line, and for how long.
Depth and current set the pause length
Two seconds is the floor and three is the working number. Depth and current decide which end of that range you use. In 20–30 m of slack water, a 2 s pause is enough for a 100 g jig to slide 1–2 m sideways before the line comes tight again. At 60–70 m with a drift running, the same jig needs 3 s, because there is more line in the water to give away and more of it to recover.
Count the pause the way you count the fall. One thousand and one, one thousand and two. Anglers who believe they are pausing for two seconds are usually pausing for one, because the pause starts when the rod stops and ends when they get bored.
Length also depends on what the jig is. A short, wide body with a low sink rate keeps sliding for most of a 3 s pause. A long, narrow body cuts down faster and finishes its slide early, so extra pause time adds drift and nothing else. Match the pause to the body.
Here is the arithmetic that settles the argument. A 130 g wide-body jig in 40 m falls at roughly 1.3 m/s on a slack line. In a 2 s pause it descends 2.6 m. That is not a fall through the water column; it is a sideways drift with a downward component. The depth change is small and the horizontal change is what the fish sees. The pause can therefore stay short even in deep water. You are not trying to drop the jig 10 m, you are trying to make it travel away from the vertical and then come back.
When the pause gets long enough to matter for depth, the technique has quietly become something else. A 6 s pause in 50 m with current is a slow fall, and a slow fall on a swept line is how you lose contact with the jig altogether.
A working jig feels light, then loads
On a drift, the line tells you three things at once: how deep the jig is, whether it is still under you, and whether it is still moving sideways. You read all three from the angle where the line leaves the rod tip, and from what the line does in the moment after you stop.
Keep that angle inside 15 degrees of vertical at the end of the drop. Under 10 degrees, the jig is fishing beneath the boat and the slide goes where you point it. Between 10 and 15, you are still fishing, but the jig is trailing. Past 20, the pause is feeding the drift, and a fish that takes is taking a jig already travelling away from it.
Three bites arrive as three different signals. On the bottom, the line goes suddenly soft and the rod tip springs forward; the jig is landing on structure and a fish is taking it in the same second, and the answer is a short sweep. At the end of the pause, you feel a single tick as the line comes tight, often followed by weight that should not be there. On the first lift, the rod loads earlier than the jig's mass predicts.
The pause bite is the one people miss, because the line is slack by design. Watch the line where it meets the water instead of watching the rod tip. A slack line that stops falling has a fish on it.
Keep your thumb near the spool and your hand off the handle. The handle recovers line between pauses and does nothing else. Anglers who crank through the pause are not slow pitching, they are speed jigging with the wrong rod and a longer face.
Weight for 20–70 m has a working band
Start with the depth in metres and multiply by 1 to 1.5 to get grams, then correct upward for current and line diameter. A 45 m drift therefore starts at 45–65 g and a 70 m drift at 70–105 g. The range comes from boats in this depth band, and it assumes a centre-weighted body and PE 1.5–2.5 mainline.
The correction that matters most is not depth, it is whether the jig can finish a slide before the boat has moved past it. A 20–30 g step up usually covers a drift under 1 kn. Above 1.5 kn the answer is a heavier jig and a shorter drift.
Wide bodies break the grams-per-metre rule in a useful way. Shimano lists its Ocea Wing Fall in 100 g, 130 g and 160 g and describes those sizes as suited to reef in 20–70 m, on a body wider than a speed jig. The extra surface slows the sink, so a wide 130 g and a narrow 90 g can fall at similar rates. The number on the jig does not tell you which one finishes its pause first.
Worked example. You drift a wreck in 45 m with a 100 g narrow body that falls at 1.4 m/s, and the boat drifts at 0.8 kn. The fall takes 45 ÷ 1.4 = 32 s. In that time the boat covers 0.8 × 0.514 × 32 = 13 m. The line angle at the end of the drop is arctan(13 ÷ 45) = 16 degrees, already past the useful limit. A 160 g wide body falls at roughly 1.9 m/s, so the drop takes 24 s and the offset falls to 10 m, which brings the angle back to 12 degrees. The pause stays at 2 s. Without that change the jig spends the pause sliding away from the wreck instead of across it.
Amberjack explain why the depth band is set where it is. NOAA Fisheries describes adults congregating over reefs, rocky outcrops and wrecks at 60–240 ft, which is 18–73 m, feeding on crab, squid and other fish. The mark is an animal sitting on structure and looking up, which is the exact geometry a pause creates.
When the pause stops producing
Four conditions turn the cadence into wasted time, and they are easy to recognise after the fact.
Drift above about 1.5 kn is the first. The jig no longer returns under the boat, the slide becomes a tow, and the next lift pulls diagonally. The fix is a sea anchor or a new drift line.
Depth beyond roughly 90 m with a light jig is the second. At 1.0 m/s the fall alone takes over 90 s, so the pause is happening while the jig is still descending. A heavier body that reaches the zone faster, and a shorter pause, will out-fish the textbook cadence in that water.
Fish pinned to the bottom in cold water are the third. They want a jig that stays within a metre of the floor. A sliding jig climbs 3–5 m off it during the lift and the slide, which is out of the feeding band. Shorten the lift to 20 cm and the pause to 1.5 s, or fish a different lure.
The fourth is structure with edges. A jig that travels sideways travels into the wreck. Over timber and rock, the slide has to be shorter than the distance to the nearest snag, which at 40 m is often less than 2 m.
Count the cycles. In 45 m with 100 g, a lift plus a 2 s pause plus the recovery costs about 6 s, so a 90 s bottom time holds roughly 12 to 14 presentations. If you are getting 20, the pauses are too short to slide. If you are getting 7, you are fishing with the brakes on.
This is the failure mode to be honest about: the advice fails the moment you apply it to a line that is already at 25 degrees. Each pause then adds scope, the next lift pulls diagonally, and after three cycles the jig is 30 m behind the boat. Most anglers read that as a dead wreck and change spots, when the drift was the problem from the first drop.
Conditions that justify a switch to fast jigging
Slow pitch loses to a fast jig whenever the fish are chasing. If bait is being pushed to the surface over 60 m of water, a 130 g wide body takes 40 s to reach the depth where the fish were, and by then they are somewhere else. Short strokes and a fast retrieve are the right answer, and they are a different article.
It also loses when the drift is a rip. A rip gives the line a fixed angle that does not relax, so the jig never gets the free second that makes the slide happen. No amount of pause fixes that; the line has to be re-set before the cadence means anything.
The rod itself is worth one sentence, because the pause is where a soft tip earns its price. A parabolic blank loads on the lift and unloads slowly, which lets the jig leave the rod tip without a snap. A stiff blank turns a 30 cm lift into a 30 cm jerk. If you are choosing between two rods, the one that bends further under the same jig is the slow-pitch rod.
The boundary of this page is deliberate. It does not tell you which jig to buy, it does not cover deep-drop weights above 300 g, and it does not claim the pause beats a live bait on a picky day. What it gives you is one decision: how long your hand stays off the line, and what has to be true about the drift before that number means anything.
Short version
- A slow-pitch jig is worked on slack line; a smooth lift on tight line uses the same lure for a different technique.
- Pause 2 s in 20–30 m of slack water and 3 s in 60–70 m with drift, and shorten it the moment the line angle passes 15 degrees.
- Start at 1–1.5 g per metre of depth, then add 20–30 g for a drift near 1 kn; wide bodies need more grams to fall at the same rate.
- The bite you will miss happens at the end of the pause, so watch the line at the water.
- Above 1.5 kn of drift or 90 m of depth, change the weight and the drift before you change the cadence.
Sources
- How To: Jigging — Shimano Fishing Australia · T2
- Saltiga Partir Jig Long — Daiwa · T2
- Greater Amberjack — NOAA Fisheries · T1
- How to Slow-Pitch Jig — Salt Water Sportsman · T3